2,4-D 475Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

ACCENSI 2,4-D 475 Dual Selective Herbicide is a water soluble liquid product with non-selective herbicidal activity against broadleaf weeds.
ACCENSI 2,4-D 475 Dual Selective Herbicide will control emerged weeds only and provides no residual control although certain plant back periods should be observed. ACCENSI 2,4-D 475 Dual Selective
Herbicide is absorbed by plant foliage and accumulates to toxic levels in the regions of growth and reproduction, upsetting the ability of plants to balance the synthesis and use of nutrients.
Visible effects are a gradual yellowing and wilting of the plants which advances to complete browning of above ground growth and deterioration of root systems. Effects may not be apparent for 7-10 days or even up to 21 days under cold or cloudy conditions.
DO NOT treat weeds under poor growing or dormant conditions such as occur in drought, water-logging, disease, insect damage, following frost, weeds heavily covered with dust or silt.
Reduced results may also occur if weeds are under stress from previous herbicide application.

APPLICATION

Boom Equipment
Application of ACCENSI 2,4-D 475 Dual Selective Herbicide plus Glyphosate 540 g/L or glyphosate mixtures in spray volumes of 25-100 L/ha is recommended.
When Lusta*, Glean*, Ally* or Associate* are included in the mixture a minimum spray volume of 30 L/ha is recommended. When Simazine is included in the mixture a minimum spray volume of 100 L/ha is recommended. Boom height must be set to ensure double overlap of nozzle patterns at the top of the weed canopy.

AERIAL EQUIPMENT

Application of ACCENSI 2,4-D 475 Dual Selective Herbicide/glyphosate mixtures should occur in a minimum spray volume of 15 L/ha.
Application under hot conditions: High temperature and/or low relative humidity cause excessive evaporation of spray droplets which may reduce results. When temperatures reach 25°C increase water volume to 30 L/ha.
DO NOT apply by aircraft when temperature is above 35°C. DO NOT use in intensive horticultural cropping areas.
Thoroughly wash aircraft, especially landing gear after each day of spraying to remove herbicide residues.

TANK MIXTURES

The ACCENSI 2,4-D 475 Dual Selective Herbicide directions for use on this label are designed to be used as a tank mixture with glyphosate herbicides. However as shown in the compatibility and surfactant addition sections of this label, it is possible to extend/improve weed control to include other foliage applied and/or residual herbicides and adjuvants.
A mixture of ACCENSI 2,4-D 475 Dual Selective Herbicide and glyphosate may be tank mixed with the following herbicides, insecticides and adjuvants where recommended in the Directions for Use tables.
Read and follow all label directions, restraints and plant back periods, withholding periods and safety directions for the tank mix products.
Dicamba 500 g/L - For improved control of Sow Thistle. Observe any regional use restrictions.
Lusta* or Glean* - Will provide control for a wide range of broadleaf weeds and grasses.
Ally* or Associate* - For improved knockdown control of Yellow Burrweed (Amsinckia), Volunteer Chickpeas, Chickweed, Common Sowthistle, Cut-leaf Mignonette, Deadnettle, Faba Beans, Mallee Catchfly, Soursob, Stagger Weed, Wild Garlic. Ally or Associate* do not provide residual in-crop weed control.

MIXING INSTRUCTIONS

ACCENSI 2,4-D 475 Dual Selective Herbicide mixes readily with water. Ensure the spray tank is free of any
residue of previous spray materials. 1. Fill the spray tank with clean water to one half of the required amount and start agitation. DO
NOT use mechanical agitators as these may cause excessive foaming when herbicides are added.
2. Where either Bonus or LI-700 is recommended at either 100 mL or 300 mL/100 L, add to tank through top mesh screen.
3. Add recommended herbicide additive / insecticide to the spray tank and mix thoroughly.
4. Add ACCENSI 2,4-D 475 Dual Selective Herbicide and mix thoroughly.
5. Top up tank to 95% of desired capacity then add the glyphosate product and the remaining water.
6. When Spraymate Activator surfactant is used, add near the end of the filling process to minimise foaming.
7. Always maintain adequate agitation during application and use the tank mix promptly.