Adama QuadrantPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

CROP TOLERANCE

All cereals After application some transient crop yellowing may occur. This usually appears as yellow or white banding on leaves. Provided the crop is not under stress from pre-emergent herbicide, root disease, insect damage, frost, dry or excessively moist conditions, the development of the crop and subsequent growth will be unaffected. Crop damage can be increased on highly alkaline sands or loams especially where free lime is present.

Oats QUADRANTTM can cause significant crop effects in oats. In addition to yellowing, crop scorch and a reduction in vigour can occur in oats, particularly if the application is delayed to later stages of crop growth. If applying QUADRANTTM to oat crops grown for hay, it is recommended that small weeds are targeted with the lower rates (where available) earlier in the application window to minimise the impact of crop effects.

MIXING To ensure even mixing, half fill the spray tank with clean water and add the required amount of product. Agitate thoroughly then add the remainder of the water. Reseal part-used product container immediately after use. Spray mixtures containing QUADRANTTM should not be left to stand overnight. Prolonged periods of exposure to cold temperatures could result in settling out of the product in the mixture.

WARNING The rubber components present in some spraying units may be affected by exposure to the solvents in QUADRANTTM and some other agricultural products. To reduce this risk it is recommended that the spray unit be thoroughly washed with a boom cleaner and fresh water after use. Contact the spray unit manufacturer to determine the suitability of the rubber components for use with agricultural products.

COMPATIBILITY DO NOT use crop oils with QUADRANTTM or with QUADRANTTM tank mixtures with other products in cereals. As formulations of other manufacturer's products are beyond the control of ADAMA Australia, all mixtures should be tested prior to mixing commercial quantities. For advice on product compatibility with QUADRANTTM, please contact ADAMA Australia.

APPLICATION Boom Sprayer: A minimum of 50 L of water per hectare should be used, however, for optimum results water rates of 70-100 L/ha are recommended. Increase the water volume if weed infestation is heavy or crop cover is dense. Complete coverage of weeds is essential. Aircraft (NSW, Vic, SA only): Apply in a minimum of 30 L water per hectare. Effective weed control will only be achieved where good coverage of the leaf surface is achieved.