Adama TrivorPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

MIXING

Shake the container prior to opening. Two-thirds fill the spray tank with clean water, and with the agitator operating, add the required quantity of TRIVOR. Top up the spray tank to the required volume with clean water with the agitator running. Maintain agitation while spraying.

APPLICATION

All Crops:

For best results, apply TRIVOR as a dilute (high volume) spray, ensuring thorough coverage of fruit and foliage throughout the crop canopy. Concentrate spraying can also be used when targeting certain pests. Refer to the Directions for Use Table for dilute and concentrate spray volume recommendations by pest. If concentrate spraying, ensure suitable equipment is used to achieve coverage of foliage and fruit and observe the maximum use rates per hectare, per application. A maximum concentration factor of 2x has been field tested and was safe to crops.

Citrus:

For young trees, the water volume will be approximately 1000 L/ha. Do not apply TRIVOR to bearing trees in a spray volume of less than 1000 L/ha. Higher volumes are usually required to achieve thorough coverage in mature/bearing trees. If the spray volume will exceed 4000L/ha, use the per hectare rate of TRIVOR and adjust the dilute concentration accordingly. Do not exceed a water volume of 8000 L/ha.

CLEANING SPRAY EQUIPMENT

After using TRIVOR, empty the tank and completely drain the system. Rinse the tank, pump, lines, hoses, filters, and nozzles by circulating clean water through the system. Drain and repeat the rinsing procedure twice.

COMPATIBILITY

As formulations of other manufacturers' products are beyond the control of ADAMA and water quality varies with location, all mixtures should be tested prior to mixing commercial quantities. Please contact your local ADAMA representative for further information on compatibility of TRIVOR with other products.