Arvesta MotsaPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

For the control of certain grass weeds in canola, chickpeas, faba beans, field peas, lentils and lupins.

GENERAL INSTRUCTIONS

MIXING
Add water to the spray tank to 10 cm above the level of agitation and ensure the agitation device is working vigorously. (There must be a minimum of 100 L of water in the tank before any pesticide is added.) If tank mixing, firstly, add any soluble liquid formulations and allow agitation for approximately one minute.
Then add Arvesta Motsa Herbicide at the point where agitation is strongest. (Do not add Arvesta Motsa Herbicide through a strainer or sieve). Allow further agitation for one minute. Half fill the spray tank.
If using wettable powder or water dispersible granules, or other emulsifiable concentration formulations, these should be added after the Arvesta Motsa Herbicide to the half full spray tank ensuring vigorous agitation.
Finally add the spraying oil/wetter and continue filling the tank to the required volume maintaining agitation at all times.
Only mix sufficient solution for immediate use. Arvesta Motsa Herbicide and any other tank mixes should be applied immediately for best results.

COMPATIBILITY

Arvesta Motsa Herbicide is compatible with the following grass herbicides: Targa, Fusilade, Sertin and Correct. (Refer to the Bayer Correct label for detail on adjuvant recommendations for that product).
NOTE: In all situations where Arvesta Motsa Herbicide is mixed with another grass herbicide, Arvesta Motsa Herbicide should be used at the full label rate specified for the target weed species.
Arvesta Motsa Herbicide may also be applied in tank mixtures with one of the following products: Sumi-Alpha1 50 EC, Sumi-Alpha1 Dual, Fastac 100 and Le-Mat.
Arvesta Motsa Herbicide should not be applied in a tank mix with Brodal. Apply as separate applications.
For information on compatibility of products not listed, please refer to Tomen Australia Limited.

APPLICATION:

Ground Application: Arvesta Motsa Herbicide should be applied with calibrated spray equipment producing a median droplet range of 200 to 300 microns VMD. Apply in a minimum of 50 litres of water per hectare. Use 150 L/ha when spraying dense populations.
Aerial Application: Arvesta Motsa Herbicide can be applied through aircraft fitted with boom or Micronair equipment. A spray volume of 20 to 30 L/ha is recommended and equipment should be adjusted to deliver droplets in the range of 200 to 250 microns VMD.
Best results will be obtained when aerial applications are made in a light crosswind. Applications should not be made during temperature inversions or in conditions of very low relative humidity. Care should be taken to avoid drift damage to adjoining grass crops.