Azoxystrobin 500 WDGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

Application DO NOT use concentration factors exceeding 4X when applying through low volume application equipment, except when applying 4Farmers Azoxystrobin 500 WG Fungicide by air. In these cases adequate coverage of all plant surfaces is still required to achieve control of diseases.

Mixing Fill tank 50 to 75% full then start agitation. Slowly pour granules into tank and maintain agitation throughout spraying. DO NOT pre-mix 4Farmers Azoxystrobin 500 WG Fungicide granules.

Application

in Tree Crops and Vines Dilute Spraying: Use a sprayer designed to apply high volumes of water up to the point of run-off and matched to the crop being sprayed. Set up and operate the sprayer to achieve even coverage throughout the crop canopy. Apply suffi cient water to cover the crop to the point of run-off. Avoid excessive run-off. The required water volume may be determined by applying different test volumes, using different settings on the sprayer, from industry guidelines or expert advice. Add the amount of product specifi ed in the Direction for Use table for each 100 L of water. Spray to the point of run-off. The required dilute spray volume will change and the spreader set up and operation may also need to be changed, as the crop grows.

Concentrate Spraying:

Use a sprayer designed to set up for concentrate spraying (that is a sprayer which applies water volumes less than those required to reach the point of run-off) and matched to the crop being sprayed. Set up and operate the sprayer to achieve even coverage throughout the crop canopy using your chosen water volume. Determine an appropriate dilute spray volume (see Dilute spraying above) for the crop canopy. This is needed to calculate the concentrate mixing rate. The mixing rate for concentrate spraying can then be calculated in the following way: Example only 1. Dilute spray volume as determined above: for example 1000 L/ha 2. Your chosen concentrate spray volume: for example 500 L/ha 3. The concentration factor in this example is 2 x (i.e. 1000L÷500L=2) 4. If the dilute label rate is 50 g/100 L, then the concentrate rate becomes 2x50, that is 100 g/100 L of concentrate spray. The chosen spray volume, amount of product per 100 L of water, and the sprayer set up and operation may need to be changed as the crop grows. For further information on concentrate spraying, users are advised to consult relevant industry guidelines, undertake appropriate competency training and follow industry Best Practices.

Compatibility/Tank Mixing

4Farmers Azoxystrobin 500 WG Fungicide may be mixed in the spray vat with any of the following products: Ambush, Bravo, Captan WG, Copper Hydroxide, Dominex*100, Dipel* DF, Karate EC, Larvin*375, Fortress*500, Talstar*80SC, Thiodan*. A mixture of 4Farmers Azoxystrobin 500 WG Fungicide with more than one of these products or with any other product may be ineffective or may cause serious damage. The use of such a mixture is not recommended and would therefore by entirely at the user’s risk. If tank mixes are to be used observe all directions, precautions and limitations on all products to be used. Note: On some tomato varieties tank mixtures of 4Farmers Azoxystrobin 500 WG Fungicide and Lorsban*500EC or Nitofol* or Supracide, or Lebaycid* or Kelthane*MF have been found to be phytotoxic. Do not tank mix these products with 4Farmers Azoxystrobin 500 WG Fungicide.