Beaut 200 EC

Manufacturer
Apparent
Category
Herbicides
Registered until
2024-06-29
Registration number
90357
Active materials
Links

GENERAL INSTRUCTIONS

APPARENT Beaut 200 EC Herbicide quickly kills marshmallow when applied directly to the leaf. Effects may not be apparent for 3 days or longer under cool, cloudy conditions. Apply treatments to weeds which have at least one true leaf to provide an adequate surface area for herbicide uptake. APPARENT Beaut 200 EC Herbicide may be used prior to sowing any cereal crop.

Weeds should be actively growing at the time of treatment. DO NOT treat weeds under poor growing or dormant conditions (such as occur in drought, waterlogging, disease, insect damage, or following frosts) as reduced weed control may result. Reduced results may also occur when treating weeds heavily covered with dust or silt. Prior herbicide application may also induce stress in weeds. Rainfall occurring up to 6 hours after application may reduce effectiveness. Heavy rainfall within 2 hours after application may wash the chemical off the foliage and a repeat treatment may be required. Delay treatment of plants wet with dew or rain, if water droplets run-off when plants are disturbed. Avoid contact with foliage, green stems, or fruit of crops, desirable plants, and trees, since severe injury or destruction may result.

Crop Establishment

APPARENT Beaut 200 EC Herbicide is recommended for control of emerged marshmallow weeds prior to crop establishment. Suitable cultivation and/or sowing operations are required to provide seedbed conditions satisfactory for crop germination and development. Spraying early to control young weeds will favor the preparation of suitable seedbeds. On friable soils and where there is only a light cover of young weeds, sowing may proceed satisfactorily from one day after spraying. In situations of heavy weed growth, sowing should be delayed until weed decay and soil conditions allow the formation of a satisfactory seedbed. Incorporation of green or decaying vegetation and roots into the seedbed by cultivation or sowing may cause retarded crop emergence, particularly in cold and/or wet conditions.

Mixing

DO NOT mix, load, or apply this product within 20m of any well, sinkhole, intermittent, or perennial stream.

  1. Fill the spray tank with one half the required amount of clean water and add the required amount of APPARENT Beaut 200 EC Herbicide.

  2. Mix well before adding the glyphosate and the remaining portion of water.

  3. Add any recommended additional herbicide/insecticide/additive.

  4. Add the surfactant near the end of the filling process to minimize foaming. Placing the filling hose below the surface of the spray solution will prevent excessive foaming. Removing the hose from the tank immediately after filling will prevent back siphoning into the water source.

When tank mixing with glyphosate, please read and follow all mixing instructions on the glyphosate label. Ensure the sprayer is free of any residue of previous spray material, and use spray solutions promptly. DO NOT use mechanical agitators as these may cause excessive foaming. Spray tanks, pumps, lines, and nozzles should be thoroughly rinsed with clean water following application to prevent corrosion.

Adjuvants

APPARENT Beaut 200 EC Herbicide should be used with an adjuvant at recommended label rates. For example, esterified vegetable oil, Apparent Mach Two Adjuvant, Apparent Stimulate Surfactant, or a non-ionic wetter.

Mixing Order

Some products may react with other products if they are not mixed in the correct order. The general mixing order of products should be:

  1. Water conditioners or buffers

  2. Water dispersible granules (WG)

  3. Wettable powders (WP)

  4. Flowable or suspension concentrates (SC)

  5. Emulsifiable concentrates (EC)

  6. Water-based or soluble concentrates

  7. Oils and wetters

It is important to ensure that each individual component of the tank mix is fully dissolved and in solution before the next product is added to the tank mix; otherwise, mixing problems may occur.

Clean up

Thoroughly clean the sprayer using the following procedure when you have finished spraying. Mix only as much spray solution as needed. Immediately after spraying, clean equipment thoroughly using this procedure. Wear appropriate protective clothing.

  1. Flush tank, hoses, boom, and nozzles with clean water.

  2. Prepare a cleaning solution of either 250 mL of ALL CLEAR DS per 100 L of water or 300 mL of household chlorine bleach (containing 4% chlorine) per 100 L of water. Ensure bleach used is fresh as it can degrade significantly over time resulting in a reduction in cleaning ability.

  3. When available, use a pressure washer to clean the inside of the spray tank with this solution. Take care to wash all parts of the tank, including the inside top surface and lid.

  4. Completely fill the sprayer with the cleaning solution to ensure contact of the cleaning solution with all internal surfaces of the tank and plumbing. Start agitation in the sprayer and thoroughly recirculate the cleaning solution for at least 15 minutes. All visible deposits must be removed from the spraying system and in cases where there is the possibility of heavy buildup of residues, the cleaning solution may need to be left in the tank overnight to ensure adequate decontamination of the tank.

  5. Flush hoses, spray lines, and nozzles for at least 1 minute with the cleaning solution.

  6. Dispose of rinsate from steps 1 to 5 in an appropriate manner.

  7. Repeat steps 2 to 5.

  8. Remove nozzles, screens, and strainers and clean separately in the cleaning solution after completing the above procedures. Be careful with filters, as they can be a main source of contamination.

  9. Rinse the complete spraying system with clean water.

The above method is only effective if the cleaning solution comes into contact with every surface or contact point that may contain even minute butafenacil herbicide residues.

Compatibility

APPARENT Beaut 200 EC Herbicide is compatible with any one of the following products: paraquat + diquat, 360 g/L paraquat, 250 g/L paraquat, prosulfocarb, trifluralin, triallate, triasulfuron, atrazine, simazine, S-metolachlor, metribuzin, diuron, isoxaflutole, 2,4-D Ester 680.

As formulations of other manufacturer’s products are beyond the control of AIRR Apparent Pty Ltd, and the quality of water may vary with location, all mixtures should be tested prior to mixing commercial quantities.

APPARENT Beaut 200 EC Herbicide must NOT be tank mixed with other formulations of Butafenacil.

Resistant Weeds Warning

GROUP 14 HERBICIDE

APPARENT Beaut 200 EC Herbicide is a member of the pyrimidindiones group of herbicides. APPARENT Beaut 200 EC has the inhibitor of protoporphyrinogen oxidase mode of action. For weed resistance management, APPARENT Beaut 200 EC HERBICIDE is a Group 14 herbicide. Some naturally occurring weed biotypes resistant to APPARENT Beaut 200 EC HERBICIDE and other Group 14 herbicides may exist through normal genetic variability in any weed population. The resistant individuals can eventually dominate the weed population if these herbicides are used repeatedly. These resistant weeds will not be controlled by APPARENT Beaut 200 EC HERBICIDE or other Group 14 herbicides. Since the occurrence of resistant weeds is difficult to detect prior to use, AIRR Apparent Pty Ltd accepts no liability for any losses that may result from the failure of APPARENT Beaut 200 EC Herbicide to control resistant weeds.

Precautions: DO NOT enter treated areas until the spray has dried, unless wearing cotton overalls buttoned to the neck and wrist (or equivalent clothing) and chemical-resistant gloves. Clothing must be laundered after each day’s use.

PROTECTION OF CROPS, NATIVE AND OTHER NON-TARGET PLANTS

DO NOT apply under weather conditions or from spraying equipment which may cause spray to drift onto nearby susceptible plants/crops, cropping lands, or pastures.

DO NOT apply or drain or flush equipment on or near trees or other plants or on areas where their roots may extend or in locations where the chemical may be washed or moved into contact with their roots.

PROTECTION OF WILDLIFE, FISH, CRUSTACEANS, AND ENVIRONMENT

Very toxic to aquatic life. DO NOT contaminate wetlands or watercourses with this product or used containers.

STORAGE AND DISPOSAL

Store in closed original container in a cool, well-ventilated area. DO NOT store for prolonged periods in direct sunlight. Triple-rinse containers before disposal. Add rinsings to spray tank. Do not dispose of undiluted chemicals on site. If recycling, replace cap and return clean containers to recycler or designated collection point.

If not recycling, break, crush, or puncture and deliver empty packaging to an approved waste management facility. If an approved waste management facility is not available, bury the empty packaging 500 mm below the surface in a disposal pit specifically marked and set up for this purpose, clear of waterways, desirable vegetation, and tree roots, in compliance with relevant local, state, or territory government regulations. Do not burn empty containers or product.

Registered for cultures
Fallow