ClomacPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS: Clomac Herbicide

MIXING: Maintain agitation at all times, including during mixing and spraying.

1. Spray Rigs that Topfill: For rigs filling through hoses, quarter-fill the tank, add Clomac, then continue filling.
2. Spray Rigs with Premix Hoppers: Three-quarter fill the hopper with water, add Clomac, dissolve, and transfer to the main tank.
3. Limited Bypass Agitation: Pre-dissolve Clomac in a bucket before adding to the main tank.
4. Tank Mixes: Follow the specified order for effective mixing.

COMPATIBILITY: Compatible with various herbicides, including broadleaf and grass herbicides, and oils/wetters (Uptake*, Ulvapron*, Pulse*).

APPLICATION: Boom Spraying Plantation Trees, Industrial/Commercial Situations, Crops, and Pastures: Apply with calibrated ground rig or aircraft. Deliver 200 to 300 micron droplets, not less than 50 L/ha for boom sprayers, or not less than 20 L/ha for aerial applications. Do not apply by aircraft in industrial/commercial situations. Specific spray volumes for hardhead thistle and silver wattle.

High Volume Hand Gun: Use the recommended mix for full coverage. Spray volume for dense 2 m high silver wattle: 30 to 40 L of spray per 100 m².

Stem Injection: Make a stem injection pocket at waist height using a ¾ length axe. Apply chemical immediately after making the injection pocket using a calibrated Phillips 5 mL vaccinator. Ensure chemical does not run out of the sides of the cut for effective control.

CLEANING SPRAY EQUIPMENT: Rinse water should be discharged to a designated disposal area or unused land away from desirable plants and watercourses.

PARTIAL CLEANING (Before spraying other labeled or tolerant crops):

1. Empty the tank and drain the system.
2. Wash inside the tank using a pressure hose.
3. Quarter-fill the tank with clean water, circulate through the pump, lines, hoses, and nozzles. Drain and repeat the procedure twice.

COMPLETE CLEANING (Before spraying susceptible crops):

1. Empty the tank and drain the system.
2. Wash inside the tank using a pressure hose.
3. Quarter-fill the tank with clean water and circulate.
4. Quarter-fill again and add an alkali detergent, circulate for at least 15 minutes.
5. Drain, remove filters and nozzles, clean separately.
6. Rinse inside the tank thoroughly with a pressure hose and flush the system with clean water.

RESISTANT WEEDS WARNING: Clomac Herbicide is a Group I herbicide with the disruptors of plant cell growth mode of action. Resistance may occur in weed biotypes due to genetic variability. Macspred Pty Ltd accepts no liability for losses resulting from the failure of the product to control resistant weeds. Strategies to minimize herbicide resistance risk are available; consult your farm chemical supplier, consultant, local Department of Agriculture, or Macspred representative.