Cypermethrin 250 EC

Manufacturer
Accensi
Category
Insecticides
Registered until
2025-06-29
Registration number
63475
Active materials
Links

GENERAL INSTRUCTIONS


INSECTICIDE RESISTANCE WARNING
For Insect resistance managementAGCENSl Cypermethrin 250 EC Insecticide is a group 3A Insecticide. Some naturally occurring insect biotypes  resistant to ACCENSI Gypermethrin 250 EC Insecticide and other group 3A insecticides may exist through normal genetic variability in any insect . - . population. The resistant Individuals can eventually dominate the insect population if AGCENSI Gypermethrin 250 EC Insecticide or other Group 3A insecticides are used repeatedly. The effectiveness of ACCENSl Cypermethrin 250 EC Insecticide on resistant Individuals could be significantly reduced.
Since occurrence of resistant indMduals is difficult to detect prior to use, AGCENSl Pty Ltd accepts no liability for any losses that may result from the failure of

ACCENSl
Cypermethrin 250 EC Insecticide to control resistant Insects ACCENSI Cypermethrin 250 EC Insecticide may be subject to specific resistance management strategies. For further information contact your local supplier, ACCENSl Pty Ltd representative or local agricultural department agronomist.

MIXING
ACCENSI Cypermethrin 250 EC Insecticide mixes readily with hard or soft water. Add the required quantity of ACCENSI Gypermethrin 250 EC Insecticide to water whilst under agitation to ensure thorough mixing. Agitate while spraying. It is not advisable to allow the mixed solution to stand for longer than 24 hours before use. In extremely alkaline water (pH 9), spray Immediately alter mixing.

APPLICATION
Good cowrage is essential to ensure adequate control. The material may be applied by ground rig or aircraft.
AERIAL APPUCATION should be under conditions normally suitable for water based emulsifiable concentrate insecticides. Apply in at least 10-20 Utres of water per hectare for colton and tomatoes and 20-30 litres of water per hectare for field peas and for other crops.
GROUND RIG APPLICATION should be In 30-100 litres per hectare for all crops except sweetcorn and tomatoes. For sweetcom, use 150-450 litres of water per hectare. For tomatoes, refer to directions for use section. Drop arms should be used on ground rig booms when crop is taller than 30 em.
Acceptable "threshold» values for eggs, larval, nymphal or adult numbers may vary according to the stage of crop development, the pest complex present and the pest management program undertaken. Alternative higher thresholds may be acceptable under certain circumstances.

TIMING
ACCENSI Cypermethrin 250 EC Insecticide is a contact and residual insecticide. For best results it should be applied as a protective treatment at regular intervals. Best results wlll be obtained by spraying at egghatch.

CROP CHECKING
Frequent and thorough checking of whole plants, seed head, flower or fruiting body as required, should be made over a random sample of plants representative of the whole crop area. inspect crops after spraying to ensure a thorough kill has been obtained, however, note that maximum kill may not be achieved until 48 hours after treatment. Then check at frequent intervals, not more than 2 days apart when insect pressure is heavy. Apply the recommended treatment as soon as a crop check indicates spraying is necessary.

Registered for culturesRate
Spring barley135 ml
Winter barley135 ml
Cotton300 - 400 ml