Ecdypro 700 WPPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

Imtrade Ecdypro is very suitable for use in orchards and vineyards using Integrated Pest Management (IPM) programs.

Mixing/Application

Add the required number of water-soluble sachets directly to the vat when about one-third full with agitators in motion. Add other products after Imtrade Ecdypro has dispersed. If pre-mixing, use at least 2 liters of water for each sachet. Each sachet contains 86g. For dilute spraying, use 1 sachet for each 1000L of water.

Dilute Spraying:

• Use a sprayer designed to apply high volumes of water up to the point of run-off and matched to the crop being sprayed.

• Set up and operate the sprayer to achieve even coverage throughout the crop canopy. Apply sufficient water to cover the crop to the point of run-off. Avoid excessive run-off.

• The required water volume may be determined by applying different test volumes, using different settings on the sprayer, from industry guidelines, or expert advice.

• Add the amount of ECDYPRO 700 WP specified in the Directions for Use table for each 100L of water. Spray to the point of run-off.

• The required dilute spray volume will change, and the sprayer set up and operation may also need to be changed as the crop grows.

Concentrate Spraying:

• Use a sprayer designed and set up for concentrate spraying (that is a sprayer which applies water volumes less than those required to reach the point of run-off) and matched to the crop being sprayed.

• Set up and operate the sprayer to achieve even coverage throughout the crop canopy using your chosen water volume.

• Determine an appropriate dilute spray volume (see Dilute Spraying above) for the crop canopy. This is needed to calculate the concentrate mixing rate.

• The mixing rate for concentrate spraying can then be calculated as described in the instructions.

INSECTICIDE RESISTANCE WARNING

For insecticide resistance management, ECDYPRO 700 WP is a Group 18 Insecticide. Some naturally occurring insect biotypes resistant to ECDYPRO 700 WP and other Group 18 Insecticides may exist through normal genetic variability in any insect population. The resistant individuals can eventually dominate the insect population if ECDYPRO 700 WP or other Group 18 Insecticides are used repeatedly. The effectiveness of ECDYPRO 700 WP on resistant individuals could be significantly reduced. Since the occurrence of resistant individuals is difficult to detect prior to use, Imtrade CropScience accepts no liability for any losses that may result from the failure of ECDYPRO 700 WP to control resistant insects. ECDYPRO 700 WP may be subject to specific resistance management strategies. For further information, contact your local supplier, Imtrade CropScience representative, or local agricultural department agronomist.

PRECAUTION

DO NOT use human flaggers/markers unless they are protected by engineering controls such as enclosed cabs.

PROTECTION OF LIVESTOCK

Low hazard to bees. May be applied on any plants at any time. DO NOT graze any treated area or cut for stock food.

PROTECTION OF WILDLIFE, FISH, CRUSTACEANS, AND ENVIRONMENT

This product may affect aquatic organisms. DO NOT contaminate dams, ponds, waterways, or drains with the concentrated product, spray mix, or used container. DO NOT apply under meteorological conditions or from spraying equipment which could be expected to cause spray drift onto adjacent areas, particularly wetlands, water bodies, or watercourses.