Factor WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

Stress conditions
Moisture stress is a particular problem, whether caused by drought or short term stresses, resulting from a combination of high temperatures and low humidity or by prior use of pre-emergence herbicides resulting in stunted root growth of weeds. An irrigation or effective rainfall must occur immediately before or after spraying if these conditions exist. Other stress conditions to avoid include use of pre-emergence herbicides resulting in stunted root growth of weeds, frost, waterlogging and extended cold conditions. Do not spray if any stress conditions are evident just prior to application.

Mixing

Add the required amount of FACTOR (see table) directly to the spray tank which should be 50% full with clean water. After the product is fully dispersed, complete filling the tank. The agitation system should be running during mixing and spraying. If agitation ceases and settling occurs, resuspend contents thoroughly before spraying. Ensure that all in-line strainer and nozzle screens in the sprayer are 100 mesh or coarser.
Add any other product next.
An oil adjuvant is essential and should be added last to the spray tank. Supercharge Elite at 1L/100L of water is the only recommended adjuvant for ground application. For aerial application, use Supercharge Elite at a rate of 1 L/ha. Supercharge Elite must be added to at least 10 times its volume of water especially where a suction (filling) probe is used.

Application

Time of application:
FACTOR is rainfast within 30 minutes. To obtain the maximum benefits of this product, weeds should be sprayed when young and actively growing. Use the lower rates for grasses with up to 4 leaves. Use the higher rates for weeds up to mid-tillering.