Floxor 400Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

MIXING FLOXOR 400 may be mixed with water or diesel. Mix only sufficient chemical for each day's use and avoid storing.

Mixing in Water: Half fill the spray tank with water, add FLOXOR 400, and complete filling. Agitate continuously for thorough mixing.

Mixing in Diesel: Half fill the tank with diesel, add FLOXOR 400, and agitate to mix contents.

Tank Mixtures: Add wettable powder or dry flowable formulations first, followed by suspension concentrates, water-soluble salts, and emulsifiable concentrate formulations (FLOXOR 400). Add spraying oils and surfactants last.

OILS AND SURFACTANTS

Oils: Use Uptake Spraying Oil at 500 mL/100 L of spray mix. Adjust for lower volumes.

Surfactants: Use non-ionic surfactant (e.g., BS1000®) at 100 mL/100 L where needed.

ATRAZINE

Avoid Hard Water: If unavoidable, add CALGON water conditioning agent at 100 g/100 L before adding any herbicide.

Agitation is Crucial: Vigorously and continuously agitate FLOXOR 400 plus atrazine tank mixes during mixing and application. Do not let the mixture stand without agitation for more than 2 hours.

Additional Agitation: Larger tanks may require additional mechanical agitation.

TOPIK 240 EC

Use Uptake Spraying Oil: For FLOXOR 400 + Topik 240 EC tank-mixes at 500 mL/100 L with a minimum of 250 mL/ha.

Do Not Mix: Avoid mixing if grass weeds are not actively growing. Use maximum label rate for Topik 240 EC.

GLYPHOSATE 450

Refer to Glyphosate Label: Follow Glyphosate 450 label for use rates and adjuvants. Do not use Glyphosate 450 at less than 1.2 L/ha in tank mixes with FLOXOR 400.

APPLICATION METHODS and WATER RATES

BROADCAST APPLICATION: Use boom sprayer with flat nozzles at 50 L/ha water. For sugarcane, use 100-400 L/ha.

GROUND DIRECTED APPLICATION: Use dropper nozzles in specific growth stages for crops.

AERIAL APPLICATION: Apply in a minimum volume of 35 L/ha water. Use calibrated equipment. Avoid high temperature, no wind, or wind towards crops.

WOODY WEED SITUATIONS

High Volume Application: Use handgun or knapsack for optimal coverage. Ensure thorough coverage.

Low Volume, High Concentrate: Use drench gun or gas-powered gun for uniform application.

Basal Bark and Cut Stump Application: Follow specific instructions for basal bark and cut stump methods.

CLEANING SPRAY EQUIPMENT

Rinsing (Water-Based Sprays): Rinse thoroughly after using FLOXOR 400. Circulate clean water through the system.

Decontamination: Wash with alkali detergent before spraying cotton. Rinse and drain.

Cleaning (Diesel-Based Sprays): Use degreaser (e.g., Caltex Kwik-D-Grease) to remove diesel traces. Rinse and clean with alkali detergent. Do not use equipment for other purposes.