Gunner 750

Manufacturer
Conquest
Category
Herbicides
Registered until
2024-06-29
Registration number
69968
Active materials
Links


GENERAL INSTRUCTIONS:

Conquest Gunner 750 WG Herbicide is a water-dispersible granule product used for around agricultural buildings and other farm non-crop situations. In addition, this product is safe for use in Clearfield Plus wheat and Clearfield barley (as per the above use pattern). This product will kill a range of standing weeds and emerging seedlings. It stops growth rapidly, although symptoms may take over 30 days to develop. Affected plants are discolored, and often growth is distorted.

The active material in Conquest Gunner 750 WG Herbicide is rapidly absorbed through foliage and roots and translocated throughout plants. Foliage treatments will provide pre-emergence control as the active material is released to the soil following plant decay. Residual control of weeds, for which the lower rate of Conquest Gunner 750 WG Herbicide is recommended, will increase when the higher rate is used. When used in Clearfield Plus wheat and Clearfield barley, The Imazamax 700 WG Label must be consulted prior to application. When used in Clearfield Plus wheat and Clearfield barley, a spray adjuvant MUST always be added, as per the “Directions for Use” table, while Boost liquid ammonium sulfate should also be added in situations indicated in the table. Good crop competition is essential for effective weed control.

MIXING:

  • Gunner 750 WG herbicide is a water-dispersible granule formulation.

  • Part fill the spray tank with water, then with the agitator running, add the required amount of product, then fill the tank with water.

  • If Conquest Gunner 750 WG Herbicide is added during filling, foaming may occur. If excessive foaming is a problem, add a suitable antifoaming agent.

  • When tank mixing with other products, follow the industry recommended mixing order by formulation types. For more complex mixtures, contact a Conquest representative.

  • Conquest Gunner 750 WG Herbicide may be applied in hard or soft water.

  • The product is corrosive to mild steel. Use ONLY stainless steel, fiberglass, plastic, or plastic-lined containers for mixing storage and application.

APPLICATION:

  • Faster control of standing weeds will result if growing conditions are favorable at and after application.

  • Rainfall within two hours of the spray mixture drying on leaves may result in reduced weed control.

  • When mixed with Imazamax 700 WG, The Imazamax 700 WG label must be consulted prior to application of Gunner 750 WG.

  • For ground application only. Apply with boom equipment in not less than 50L/ha water using flat fan nozzles. Avoid overlap and do not overspray headlands.

  • DO NOT apply by aircraft.

  • DO NOT apply by mister.

  • Gunner 750 WG Herbicide should be applied a minimum of two hours before rainfall or irrigation.

  • DO NOT apply Gunner 750 WG Herbicide more than once per growing season.

EQUIPMENT CLEANUP:

  • Thoroughly flush all spray equipment with water following the use of Gunner 750 WG Herbicide and before use with other products.

  • Rinse water should NOT be discharged where it will reach streams, water bodies, or natural vegetation.

COMPATIBILITY:

  • For faster knockdown of weeds, certain other herbicides may be mixed with Conquest Gunner 750 WG Herbicide.

  • Bipyridyl herbicides (e.g., Paraquat) are NOT compatible with Conquest Gunner 750 WG. Mixtures of this type will result in poor weed control.

  • Gunner 750 WG is chemically compatible with Alpha Forte and Alpha Duo Insecticides. It is also chemically and biologically compatible with Conquest Imazamax 700 Herbicide, Conquest Nitro 240 Herbicide, Conquest Recon 520 Herbicide, Conquest Corsair, Conquest 570 LVE MCPA, Conquest 750 MCPA Herbicide, Conquest Bromo 200 and Conquest Brom M Herbicides, Conquest Racer, and Conquest Crossfire Herbicides. For use with other products, contact a Conquest representative.

Mixes with LontrelTM5 Advanced in Clearfield Plus wheat and Clearfield barley:

  • Tank mixes with LontrelTM5 Advanced at 150mL/ha will provide control of composite and legume weeds. Refer to LontrelTM5 Advanced label.

Mixes with Conquest 570 LVE Herbicide in Clearfield Plus wheat and Clearfield barley:

  • Tank mixes with Conquest 570 LVE Herbicide at 500mL/ha will provide control of composite and brassicaceous weeds. Refer to Conquest 570 LVE label.

Registered for cultures
Winter barley
Spring barley