Ken-Mide 900 WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

Application:

• Best results are obtained by applying Kenso Agcare Ken-Mide 900 WG Herbicide to cool, wet soil.

MIXING:

• Ken-Mide 900 WG Herbicide is a Wettable Granule formulation designed to be blended with water and applied as a spray.
• When using larger boomsprays, pre-mixing may be necessary. Follow these steps:
  1. Partly (30%) fill the boomspray tank with water.
  2. Slowly add the required amount of Ken-Mide 900 WG Herbicide into a pre-mixing vessel while agitating well.
  3. Ensure high water volumes and do not add to the spray tank until the pre-mix is fully dissolved. This may take several mixes to ensure the correct amount is added to the boomspray tank.
  4. Add the pre-mixed Ken-Mide 900 WG Herbicide into the boomspray tank with the agitation system operating.
  5. Fill up the correct volume with water.
  6. The mixture must be kept in suspension at all times by continuous agitation.
  7. Tank-mixtures should be tested for physical compatibility and efficacy before use.
  8. Do not mix with MCPA. If tank mixing, Ken-Mide 900 WG Herbicide must be in suspension before adding other herbicides, insecticides, or surfactants.
  9. Wash the sprayer thoroughly after use.

EQUIPMENT:

• Ensure the sprayer is clean, using a suitable spray and boom cleaner as directed.
• For turf situations, up to 100L/ha spray volume is recommended.

RESISTANT WEEDS WARNING:

• Kenso Agcare Ken-Mide 900 WG Herbicide belongs to the amide group of herbicides (Group D). Weed resistance may occur with repeated use, and resistant weeds will not be controlled by this herbicide.
• No liability is accepted for losses resulting from the failure of Ken-Mide 900 WG Herbicide to control resistant weeds.
• Consult with local authorities or Kenso Agcare representatives for alternative treatments and strategies to minimize the risk of herbicide resistance.