Ken-Up Aquatic 360

Manufacturer
Kenso Corporation
Category
Herbicides
Registered until
2024-06-30
Registration number
55654
Active materials
Links

GENERAL INSTRUCTIONS

Kenso Agcare Ken-Up Aquatic 360 Herbicide is a non-selective, water-soluble liquid herbicide effective in the control of many annual and perennial grasses and broadleaf weeds in crop areas, land preparations, and non-crop areas. It is not recommended for use prior to transplanting tomato seedlings. The product is inactivated in soil and does not provide residual weed control. For residual control, see the tank mixtures section of this label.

Kenso Agcare Ken-Up Aquatic 360 Herbicide is absorbed by the plant foliage and green stems and moves through the plant from the point of contact to the root system. Visible effects are gradual yellowing and wilting of the plant, which advances to complete browning of growth above the ground and deterioration of underground plant parts. These effects take 3 to 7 days on annual weeds, whereas on perennial weeds, it may take 2 to 3 weeks or longer depending on weather conditions following spraying.

Do not disturb treated weeds by cultivation, sowing, or grazing for one day after treatment of annual weeds and 7 days for perennial weeds to ensure uptake of herbicide.

No withholding period is required for this product. However, to ensure herbicide absorption, grazing of treated areas should be delayed at least one day after treatment of annual weeds and 7 days for perennial weeds. Certain plants such as soursob, St Johns Wort, and Bracken may be naturally toxic to stock. Where known toxic plants are present, grazing should be delayed until the complete browning of treated plants has occurred.

Do not treat weeds under poor growing or dormant conditions (such as occur in drought, waterlogging, disease, insect damage, or following frosts) as reduced weed control may result. Reduced efficacy may also occur when treating weeds heavily covered with dust or silt. Delay treatment of plants wet with dew or rain if water droplets run off when plants are disturbed.

RESISTANT WEEDS WARNING

Kenso Agcare Ken-Up Aquatic 360 Herbicide is a member of the glycine group of herbicides. The product has the inhibitors of EPSP synthase mode of action. For weed resistance management, the product is a Group M herbicide.

Some naturally-occurring weed biotypes resistant to the product and other Group M herbicides may exist through normal genetic variability in any weed population. The resistant individuals can eventually dominate the weed population if these herbicides are used repeatedly. The resistant weeds will not be controlled by this product or other Group M herbicides.

Since the occurrence of resistant weeds in difficult to detect prior to use, Kenso Corporation (M) Sdn. Bhd. accepts no liability for any losses that may result from the failure of this product to control resistant weeds.

MIXING

This product mixes readily with water. The following procedure for mixing should be undertaken:

  1. Clean spray tank, pumps, lines, and nozzles and assure it is free from residues of previous spray materials.
  2. Fill the spray tank with half the required amount of clean water and start agitation. Add the recommended herbicide/insecticide to the spray tank, mix thoroughly and then add the required amount of Ken-Up Aquatic 360 and mix well before adding the remaining water.
  3. If surfactant is required, add this last to minimize foaming. The use of a mechanical agitator is not recommended as it may cause excessive foaming.
  4. Agitate well before and during spraying.

Always use clean water when preparing the spray solution since hard water containing calcium salts could inactivate glyphosate. Spray solutions of this product should be mixed, stored, and applied only in stainless steel, aluminum, brass, copper, fiberglass, plastic, or plastic-lined spray tanks. Do not mix or store the product or spray solutions in galvanized steel or unlined steel (except stainless steel). Use the spray solution promptly.

TANK MIXES

Herbicides

This product may be mixed with the following products. Read and follow all label directions, restraints, plant back periods, withholding periods, safety directions, etc for the tank mix product.

Ken-Chlor 750, Ken-Met 600, Pendi 330, Ken-Gran 750, 570 LV MCPA, Ox 240, Dicamba 500, Ken-Ester LV 680, sulfometuron methyl.

Atrazines/Simazines

DO NOT apply Atrazine 900 tank mixes for barnyard grass control. Ken-Up Aquatic 360 may be tank mixed with Atrazine 900 or Simazine 900 for knockdown and residual weed control.

NOTE: Atrazine is NOT approved for use in non-agricultural situations.

Liquid Ammonium Sulphate (e.g., Kenso Agcare Ammo-Flo Herbicide Adjuvant)

RATE: 2L/100L spray solution

The addition of liquid ammonium sulfate to Ken-Up Aquatic 360, when used to control ANNUAL weeds, MAY improve the performance of Ken-Up Aquatic 360 under adverse environmental conditions such as cool, cloudy weather and assist in minimizing the antagonism in tank mixes of Ken-Up Aquatic 360 and flowable triazine herbicides. Use only liquid ammonium sulfate, NOT prilled or granulated forms.

Ammonium sulfate may be corrosive to metal parts of the sprayer. Thoroughly flush tanks, pumps, and nozzles with water after use.

Insecticides

This product is compatible with the following insecticides: Dimethoate, Imidan, Omethoate, Kensban 500, Fenitrothion ULV, and emulsifiable concentrates of dimethoate and fenitrithion.

Silken Penetrant

It is recommended to add Silken Penetrant at the rate of 200mL/100L spray solution when treating bracken (boom application), gorse, Eucalypt suckers, and lantana.

APPLICATION

Boom Equipment

Use at a spray volume of 75 to 200 L/ha. When using this product at 500mL-1.5L/ha, spray volumes in the range of 25-100L/ha are preferred. Fan nozzles at a pressure of 240 - 280 kPa are recommended. Boom height must be set to ensure double overlap of nozzle patterns at the top of the weed canopy.

Knapsack and Handgun Equipment

Adjust equipment to deliver a fine spray pattern and ensure a complete and uniform wetting of all foliage. For handgun equipment, a D6 nozzle is recommended operating at 400-700 kPa. Do not spray in conditions conducive to spray drift.

Wiper Equipment

Wiper Equipment (e.g., ropewick, canvas, felt, or carpet applicators) may be used to apply Ken-Up Aquatic 360 Herbicide onto weeds growing in oilseed crops, sugarcane, cotton, seed and pod vegetables, tree and vine crops specified in this label, pasture, and non-crop areas. Avoid contact with desirable vegetation. Operate wiper equipment a minimum of 10cm above the crop or pasture. Weeds should be at least 15cm above the crop or pasture at the time of application. The speed of travel should be no greater than 8km/h. Best results are achieved at lower speeds and where two applications are made in opposite directions (double pass).