Laguna Xtreme 800 WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

For the control of various diseases of bananas, peanuts, grapes, cereal crops, vegetables and other crops.

MIXING
Add the required quantity of Laguna Xtreme 800 WG Fungicide to water in the spray vat while stirring or with agitators in motion. Add the required amount of Agridex* (beans, peanuts, sugar cane) or water miscible oil (bananas) and mix thoroughly.

APPLICATION
SPECIAL INSTRUCTIONS FOR GRAPE VINES:
Dilute Spraying: Use a sprayer designed to apply high volumes of water up to the point of run-off and matched to the crop being sprayed. Set up and operate the sprayer to achieve even coverage throughout the crop canopy. Apply sufficient water to cover the crop to the point of run-off. Avoid excessive run-off. The required water volume may be determined by applying different test volumes, using different settings on the sprayer from industry guidelines or expert advice. Add the amount of Laguna Xtreme 800 WG Fungicide specified in the Directions for Use table for each 100L of water. Spray to the point of run-off. The required dilute spray volume will change and the sprayer set up and operation may also need to be changed, as the crop grows.
Concentrate Spraying: Use a sprayer designed and set up for concentrate spraying (ie, a sprayer which applies water volumes less than those required to reach the point of run-off) and matched to the crop being sprayed. Set up and operate the sprayer to achieve even coverage throughout the crop canopy using your chosen water volume. Determine an appropriate dilute spray volume (See Dilute spraying above) for the crop canopy. This is needed to calculate the concentrate-mixing rate. The mixing rate for concentrate spraying can then be calculated in the following way:

Example Only:
a. Dilute spray volume as determined above (eg 1 500L/ha)
b. Your chosen concentrate spray volume (eg 500L/ha)
c. The concentration factor in this example is 3 times (ie, 1500 ÷ 500 = 3)
d. If the dilute label rate is 30g/100L then the concentrate rate becomes 3 x 30, ie 90g/100L of concentrate spray.
e. The chosen spray volume, amount of product per 100L of water and the sprayer set up and operation may need to be changed as the crop grows.
f. Do not use a concentrate rate higher than that specified in the Critical Comments.
g. For further information on concentrate spraying, users are advised to consult relevant industry guidelines, undertake appropriate competency training and follow Industry Best Practices.