Agrobase Australia
Lambda 250 CS Registration expired
Conquest - Insecticide
69701

For the control of certain insect pests in Cotton, Barley, Wheat and various field crops.

MIXING
For ground or aircraft application with water:
Conquest Lambda 250 CS Insecticide mixes readily with hard or soft water. Add the required quantity of product to water whilst under agitation to ensure thorough mixing. Agitate while spraying. It is not advisable to allow the mixed solution to stand longer than 24 hours before use. In extremely alkaline water (pH 9) spray immediately after mixing.
For ULV (ultra low volume) application with oil:
It is recommended that Conquest Lambda 250 CS Insecticide be mixed with a mineral, spraying oil. See Compatibility section for a list of recommended mineral spraying oils. Add the required quantity of product to oil whilst under agitation to ensure through mixing. Agitate while spraying. It is not advisable to allow the mixed solution to stand longer than 24 hours before use.

APPLICATION
Good coverage is essential to ensure adequate control. The product may be applied by ground rig or aircraft. DO NOT apply if rain is expected within 6 hours. Acceptable 'threshold' values for eggs and larval numbers may vary according to the stage of crop development and the pest management program undertaken. Alternative higher thresholds may be acceptable under certain circumstances.
Diluted with water:
For ground rigs the volume of liquid applied should be 30 to 100 Uha. Aerial application should be under conditions normally suitable for water-based insecticides. Apply in at least 10 to 20 L water/ha.
Mixed with oil:
Apply the recommended rate of Conquest Lambda 250 CS Insecticide bulked with oil to total volume of 3 to 5 Uha for cotton, sorghum and sunflowers. The total volume for all other crops should be 1.5 L/ha.

TIMING
This product is a contact and residual insecticide. Best result will be obtained if Conquest Lambda 250 CS Insecticide is applied as a protective treatment at regular intervals. However, if spraying frequency based on scouting, then for Helicoverpa spp. application at egg hatch will give optimum results.

COMPATIBILITY
This product, when applied, as a water-based spray is compatible with the following actives: fluazifopp, pirimiphos-methyl, procynnidone, pirimicarb, paraquat /diquat, glyphosate-trimesium and paraquat.
This product when used in an ultra low volume application is compatible with the following mineral spraying oils: DC Tron Cotton*, DC Tron*, Ulvapron*, Trycol*, Caltex Summer Spray Oil* and Omex*.

Effective
Crops
Cotton
BBCH
0 - 0
Registred norm
60 - 85
Preharvest Interval
21
Crops
Spring barley
BBCH
0 - 0
Registred norm
12 - 40
Preharvest Interval
14
Crops
Winter barley
BBCH
0 - 0
Registred norm
12 - 40
Preharvest Interval
14
Crops
Winter wheat
BBCH
0 - 0
Registred norm
12 - 40
Preharvest Interval
14
Crops
Spring wheat
BBCH
0 - 0
Registred norm
12 - 40
Preharvest Interval
14
Crops
Alfalfa, Lucerne
BBCH
0 - 0
Registred norm
9 - 40
Preharvest Interval
14
Crops
Pasture
BBCH
0 - 0
Registred norm
9 - 40
Preharvest Interval
14
Crops
Sorghum
BBCH
0 - 0
Registred norm
18 - 70
Preharvest Interval
14
Crops
Sunflowers
BBCH
0 - 0
Registred norm
36 - 70
Preharvest Interval
28
Crops
Soybeans
BBCH
0 - 0
Registred norm
60 - 70
Preharvest Interval
21
Crops
Navy beans
BBCH
0 - 0
Registred norm
60 - 70
Preharvest Interval
14
Crops
Mung beans
BBCH
0 - 0
Registred norm
60 - 70
Preharvest Interval
14
Crops
Canola
BBCH
0 - 0
Registred norm
9 - 36
Preharvest Interval
7
Crops
Beans
BBCH
0 - 0
Registred norm
9 - 36
Preharvest Interval
7
Crops
Chickpeas
BBCH
0 - 0
Registred norm
9 - 36
Preharvest Interval
7
Crops
Vetch
BBCH
0 - 0
Registred norm
9 - 36
Preharvest Interval
7
Crops
Peas
BBCH
0 - 0
Registred norm
9 - 36
Preharvest Interval
7
Crops
Lupins
BBCH
0 - 0
Registred norm
9 - 24
Preharvest Interval
14