Lorsban 750 WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS
MIXING
SPRAY MIX
One third fill the spray tank with water and add the required number of water soluble pre-packs to the strainer/sieve. Complete filling allowing the remaining water to run over the bags. The bags will completely dissolve in a few minutes.
OR
Add the required number of pre-packs to a mixing bucket and add enough water to completely cover the bags. Stir until the bags are completely dissolved and pour the pre-mix into the spray tank. Triple rinse the bucket and stirring implement, adding the rinse water to the spray tank.
Agitate continuously to ensure thorough mixing before and during application. Only mix sufficient chemical for each day’s work.
Tank mixtures: Lorsban 750 WG should be added to  the partially full spray tank first, followed by other  dry flowables, suspension concentrates (flowables), aqueous concentrates and then emulsifiable concentrate formulations.

COMPATIBILITY
Lorsban 750 WG is compatible with benomyl, carbendazim, dicofol, dinocap, dodine, fenarimol, mancozeb, propargite, superior oils, tetradifon, thiram, thiophanate-methyl, ziram.

APPLICATION
Unless specified, it is essential to apply Lorsban 750 WG in sufficient water to obtain thorough coverage.
Apply through accurately calibrated equipment.

CLEANING SPRAY EQUIPMENT
Rinse water should be discharged onto a designated disposal area or, if this is unavailable onto unused land away from homes and water courses.
After using Lorsban 750 WG, empty the spray equipment completely and drain the whole system. Quarter fill the spray equipment with clean water and circulate through the pump, line, hoses and nozzles. Drain and repeat procedure twice.

INSECTICIDE RESISTANCE WARNING
For insecticide  resistance management Lorsban 750 WG Insecticide is a Group 1B Insecticide.
Some naturally occurring insect biotypes resistant to Lorsban 750 WG Insecticide and other Group 1B insecticides may exist through genetic variability in any insect population. The resistant individuals can eventually dominate the insect population if Lorsban 750 WG Insecticide or other Group 1B insecticides are used repeatedly. The effectiveness of Lorsban 750 WG Insecticide on resistant individuals could be significantly reduced. Since occurrence of resistant individuals is difficult to detect prior to use, Dow AgroSciences Australia Limited accepts no liability for any losses that may result
from failure of Lorsban 750 WG Insecticide to control resistant insects.
Lorsban 750 WG Insecticide may be subject to specific resistance management strategies. For further information contact your local supplier or Dow AgroSciences representative.