LVE 600 MCPAPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS
Before opening, carefully read DIRECTIONS FOR USE, PROTECTION OF CROPS, NATIVE AND OTHER NON-TARGET PLANTS, SAFETY DIRECTIONS and FIRST AID instructions.
Weeds should be sprayed while actively growing and at their most susceptible stage. As a general guide, annuals should be sprayed when young and perennials just prior to appearance of bud stage. Extremes of cold or drought are unfavourable. The best conditions are when soil is moist, weather is fine and rain unlikely within 6 hours of application.

APPLICATION INFORMATION
BOOM SPRAYING - Use 30-120 L/ha of water.
AERIAL SPRAYING - Use 10-90 L/ha of water.
EQUIPMENT MAINTENANCE AND USAGE Equipment that has been used for this chemical should not be used for the application of other materials to sensitive plants, unless it has been well washed out with hot soapy water or 1% solution of ammonia, followed by several clear water rinses.

COMPATIBILITY
This product may be tank mixed with Broadstrike Herbicide, bromoxynil, dicamba, diflufenican, diuron (500 g/L or 900 g/kg), chlorsulfuron, diclofop-methyl, glyphosate, metsulfuron, Hotshot Herbicide, Lontrel, Lontrel 750 SG Herbicides, Sertin, Spray·Seed, Starane Advanced Herbicide, flowable terbutryn, Tigrex, Tordon 242 Herbicide, Torpedo Herbicide, triasulfuron, Tribunil and Wildcat.
When mixing with diclofop-methyl, add an approved surfactant and do not exceed 580 mL/ha of Dow AgroSciences LVE 600 MCPA Herbicide. For consistent results, use a minimum of 80 L water per hectare by ground and 30 L water by air.
NOTE:
1. As formulations of other manufacturers’ products are beyond the control of Dow AgroSciences all mixtures should be tested on a small scale before mixing in the spray tank.
2. Tank mixing instructions:  Fill the spray tank 1/4 full of water and agitate. Add wettable powders and water dispersible granules first.
Agitate until these are uniformly dispersed, meanwhile adding water until the tank is 90% full. Add suspension concentrates (flowables) then soluble concentrates. Emulsifiable concentrates go in last. Top off the tank with water and continue agitation until all the ingredients are properly mixed. Observe any mixing sequence instructions mentioned on the tank mix products.

RESISTANT WEEDS WARNING
Dow AgroSciences LVE 600 MCPA Herbicide is a member of the Phenoxys group of herbicides. Dow AgroSciences LVE 600 MCPA Herbicide has the disruptors of plant cell growth mode of action. For weed resistance management Dow AgroSciences LVE 600 MCPA Herbicide is a Group I herbicide. Some naturally occurring weed biotypes resistant to Dow AgroSciences LVE 600 MCPA Herbicide and other Group I herbicides may exist through normal genetic variability in any weed population. The resistant individuals can eventually dominate the weed population if these herbicides are used repeatedly. These resistant weeds will not be controlled by Dow AgroSciences LVE 600 MCPA Herbicide or other Group I herbicides. Since the occurrence of resistant weeds is difficult to detect prior to use, Dow AgroSciences Australia Limited accepts no liability for any losses that may result from the failure of Dow AgroSciences LVE 600 MCPA Herbicide to control resistant weeds.