Nitro 360Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

CLEANING SPRAY EQUIPMENT Before using Nitro 360: Ensure that the recommended clean–out procedures for the previous product (particularly sulfonylurea herbicides) sprayed with the equipment were done properly. After using Nitro 360:

• Empty the tank and drain the whole system.

• Thoroughly wash inside the tank using a pressure hose, drain the tank, and clean filters in the tank, pump line, and nozzles.

• Use of a household detergent will aid in cleaning the equipment. Add detergent to the part-filled spray tank and thoroughly circulate through pumps, hoses, and nozzles.

• Drain the system and thoroughly rinse twice with clean water.

• Rinse water should be discharged onto a designated disposal area, or if this is unavailable, onto unused land away from desirable plants and water sources.

MIXING To ensure even mixing, half-fill the spray tank with clean water, add the required amount of Nitro 360. Add spray additive and agitate thoroughly, then add the remainder of the water. Agitate again before spraying commences.

ADJUVANTS AND SPRAY ADDITIVES Always apply Nitro 360 Herbicide with a crop oil. Nitro 360 Herbicide may be applied with CONQUEST GLISARIN at 1L/100L water or with Conquest In2Pro at 0.5-1L/100L water. (Use the higher rate of oil when weeds are large or if spraying conditions are less than optimal). Nitro 360 Herbicide is compatible with ammonium sulfate products such as CONQUEST AMSUL 417. When mixing Nitro 360 Herbicide with atrazine use Conquest In2Pro at 1L/100L as the adjuvant. The addition of ammonium sulfate is recommended to improve performance of this tank mix. Nitro 360 Herbicide is not compatible with Hot-Up* Spray Adjuvant or Freeway* Gold Penetrant.

APPLICATION

• Ground Application: Nitro 360 Herbicide should be applied with calibrated spray equipment. DO NOT apply with spray droplets smaller than a MEDIUM spray droplet size category. Apply in a minimum of 50 liters of water per hectare. Use 150 L/ha when spraying dense populations.

• Aerial Application: Nitro 360 Herbicide can be applied through aircraft fitted with boom or Micronair equipment. DO NOT apply with spray droplets smaller than a MEDIUM spray droplet size category. A spray volume of 20 to 30 L/ha is recommended. Best results will be obtained when aerial applications are made in a light crosswind. Applications should not be made during temperature inversions or in conditions of very low relative humidity. Care should be taken to avoid drift damage to adjoining grass crops.

USE OF NITRO 360 ON PASTURE LEGUME (LUCERNE, CLOVER, AND MEDIC) SEED CROPS AND PASTURES AND PASTURE HERBS Nitro 360 Herbicide has been demonstrated to be safe when applied to the following cultivars during early establishment:

• Pasture legumes

• Lucerne and Medics (Medicago spp.)

• Serradella (Ornithopus spp.)

• Pasture herbs: Chicory (Puna II) and Plantain (Tonic) Apply Nitro 360 Herbicide when plants have reached 2-4 trifoliate leaf stage, or after 40 days from sowing. Some pasture varieties may exhibit an initial reduction in crop vigor or biomass, however, these symptoms are transient and crops recover fully with no effect on yield.