Nufarm Weedmaster DuoPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS CONTINUED

Tank Mixtures - Compatibility and Mixing

This product may be tank-mixed with various herbicides, insecticides, and additives. It is essential to follow proper mixing procedures to ensure effective and safe application. Here are the steps for mixing additional products:

1. Fill the spray tank 1/3 to 1/2 full with clean water and start agitation.
2. Add the recommended herbicide, insecticide, or additive to the spray tank and mix thoroughly.
3. When ammonium sulfate is recommended, add Liase at a rate of 2 L/100L spray solution and mix thoroughly.
4. Add weedmaster DUO and the remaining water. Mix thoroughly.
5. Add surfactant, if required, near the end of the filling process to minimize foaming.
6. Always maintain adequate agitation during application and use the tank mix promptly.

Tank Mixtures - Herbicides Compatibility:

This product is compatible with various herbicides including Atrazine Hi-Load, Estercide Xtra 680, Grunt WDG 750, Kamba 500, Simazine flowable, Oust, Yield, Rifle 440, Stomp 330, Nufarm Surpass, Ally/Associate, Logran/Nugran, Flandor 500, LVE MCPA, and Striker.

The addition of Striker at 75mL/ha to recommended rates of weedmaster DUO before planting wheat or barley may improve knockdown and speed up the visible signs of phytotoxicity. Note: Specific compatibility agents may be required for certain mixtures, so seek advice.

Tank Mixtures - Additives (Ammonium Sulphate):

• Add Liase to water first at a rate of 2 L/100L spray solution.
• Liase may improve the performance of weedmaster DUO under adverse environmental conditions and minimize antagonism in tank mixes of weedmaster DUO and flowable triazine herbicides.

Note: Liase may be corrosive to metal parts of the sprayer, so thoroughly flush tanks, pumps, and nozzles with water after use.

Tank Mixtures - Insecticides Compatibility:

This product is compatible with insecticides such as Dimethoate, Fenitrothion 1000, Imidan, Le-Mat/Comrad, Lorsban 500, Metasystox, Perfekthion EC400, ULV, and emulsifiable concentrates of dimethoate and fenitrothion.

Application Information:

• This product is a non-selective translocated herbicide, meaning it can affect a wide range of weeds.
• Direct spray contact or slight drift may cause severe injury or destruction to any growing crop or other desirable plants, including trees.
• Clean all equipment after use by thoroughly washing it with water.

Boom Equipment Application:

• Use recommended rates of this product in 75-200 L of clean water per hectare.
• For conservation tillage at 500 mL-1.5 L/ha, spray volumes of 25-100 L/ha are preferred.
• Fan nozzle equipment is recommended, using pressures in the range 240-280 kPa.
• Set boom height to ensure double overlap of nozzle patterns at the top of the weed canopy.

High Volume Application (Knapsack and Handgun Equipment):

• Adjust equipment to achieve an even spray pattern.
• For handgun equipment, a D6 spray tip or equivalent, and an operating pressure of 400-700 kPa are recommended.
• Apply to ensure complete and uniform wetting of all foliage.

Low Volume Application (Gas Gun or Splatter Gun):

• Apply as an even spray to cover all foliage.
• Refer to the "Weeds Controlled" section for the dilution and volume of mixture to be applied.