Piri-Ken 500 WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS - Kenso Agcare Piri-Ken 500 WG Aphicide

MIXING:

1. Fill the tank 50 to 75% full, then initiate agitation.
2. Slowly pour granules into the tank while maintaining agitation throughout spraying.
3. DO NOT pre-mix Kenso Agcare Piri-Ken 500 WG Aphicide granules.

APPLICATION:

• If applying when the temperature is below 15°C, ensure thorough spray coverage for effective aphid control.

FRUIT CROPS - TREE AND VINE CROPS:

Dilute Spraying:

• Use a sprayer designed for high water volumes, matched to the crop.
• Set up the sprayer for even coverage throughout the crop canopy.
• Apply sufficient water to cover the crop to the point of run-off, avoiding excessive run-off.
• Determine water volume based on test volumes, industry guidelines, or expert advice.
• Add the specified amount of product from the Directions for Use table for each 100L of water.
• Spray to the point of run-off, adjusting dilute spray volume and sprayer setup as the crop grows.

Concentrate Spraying:

• Use a sprayer designed for concentrate spraying (lower water volumes).
• Set up the sprayer for even coverage throughout the crop canopy with your chosen water volume.
• Determine an appropriate dilute spray volume for the crop canopy.
• Calculate the concentrate mixing rate using the concentration factor.
  • Example: If dilute spray volume is 1500L/ha and concentrate spray volume is 500L/ha, the concentration factor is 3 (1500L ÷ 500L).
  • If dilute label rate is 10mL/100L, then the concentrate rate becomes 3 x 10, i.e., 30mL/100L of concentrate spray.
• Adjust spray volume, product amount per 100L, and sprayer setup as the crop grows.

Note: For concentrate spraying, refer to industry guidelines, undergo competency training, and follow best practices.

COMPATIBILITY:

• Kenso Agcare Piri-Ken 500 WG Aphicide can be mixed with Wetspray* and Omite* in the spray vat.
• Mixing with more than one of these products or any other may be ineffective or cause serious damage.
• Such mixtures are not recommended and would be entirely at the user's risk.