Steady 750WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

General Instructions:

Crop Safety:

Chickpeas: Application of RELYON ISOXAFLUTOLE 750 WG HERBICIDE PSPE to chickpeas planted in sandy or gravely soils, or soils low in clay or organic matter may result in crop damage. Heavy rains after the application of RELYON ISOXAFLUTOLE 750 WG HERBICIDE may cause crop damage, particularly in sandy or gravely soils. Application of RELYON ISOXAFLUTOLE 750 WG HERBICIDE + simazine in sandy or gravely soils may result in severe crop damage. Varietal Tolerance: RELYON ISOXAFLUTOLE 750 WG HERBICIDE is NOT recommended for use with the chickpea variety Yorker. Application of RELYON ISOXAFLUTOLE 750 WG HERBICIDE post-sowing pre-emergent to crops of Yorker variety chickpeas can result in unacceptable crop damage and may result in yield loss.

Crop Rotation Recommendations:

RELYON ISOXAFLUTOLE 750 WG HERBICIDE may be applied to chickpea crops where the following crop will be chickpeas, or where the land will be left fallow. The following re-cropping instructions apply to following crops other than chickpeas. • Prolonged dry periods or cold conditions may result in extended re-cropping intervals, even if rainfall exceeds the required amount (listed in the table below). If in doubt, contact your local supplier, Nutrien Ag Solutions representative or local Department of Agricultural agronomist. • Heavy rainfall after an extended dry period may result in the reactivation of RELYON ISOXAFLUTOLE 750 WG HERBICIDE. This can lead to transient bleaching or crop stunting. • Use on soils with a pH less than 7.0 has not been extensively tested, and may result in extended re-cropping intervals. • Cultivation is recommended prior to re-cropping. • Minimum re-cropping intervals apply for all crops following RELYON ISOXAFLUTOLE 750 WG HERBICIDE application. For advice on crops not listed below, please contact your local supplier, Nutrien Ag Solutions representative or local Department of Agricultural agronomist.

Sugarcane: There are 3 key guidelines for maintaining crop safety when using RELYON ISOXAFLUTOLE 750 WG HERBICIDE in sugarcane.

1. DO NOT apply to soils with a low binding potential, that is with a C.E.C. below 4.5 meq/100 g, or an O.C. of 1.0% or less (unless C.E.C. is greater than 9.5 meq/100 g).

2. DO NOT apply to areas which have poor drainage or poor root development.

3. Add Paraquick 250 Herbicide to RELYON ISOXAFLUTOLE 750 WG HERBICIDE to minimize foliar uptake when applying as a broadcast spray to plant cane.

Mixing:

Partly fill the spray tank with water. Start agitation. Add the correct amount of RELYON ISOXAFLUTOLE 750 WG HERBICIDE to the spray tank with the agitation system running. When tank-mixing with Paraquick 250 Herbicide, ensure that RELYON ISOXAFLUTOLE 750 WG HERBICIDE is added to the spray mixture first, followed by Paraquick 250 Herbicide to ensure thorough mixing. Continue agitation while topping up the tank with water and while spraying. Use prepared spray mixture on day of preparation. DO NOT allow spray mixture to stand overnight.

Tank Mixtures:

Read and follow all label directions including restraints, spray drift restraints, mandatory no-spray zones, critical comments, withholding periods, regional use restrictions and safety directions for the tank mix product.

Application:

Sugarcane: Apply in a minimum spray volume of 250 L/ha. For best results flat fan nozzles are recommended. Select the lowest pressure (within the recommended nozzle operating range), to reduce drift. Use a nozzle size that delivers a medium to coarse droplet at the selected operating pressure. RELYON ISOXAFLUTOLE 750 WG HERBICIDE can be applied to hot and dry soils, without the risk of breakdown by sunlight. This ultraviolet stability removes the need for immediate soil incorporation of the product. RELYON ISOXAFLUTOLE 750 WG HERBICIDE is activated by rainfall or irrigation, which is required to carry the herbicide into the root zone of the germinating weeds. Weed escapes may occur after spraying RELYON ISOXAFLUTOLE 750 WG HERBICIDE if weed germination occurs before the chemical is activated OR carried to the depth of the weed root zone. Under prolonged dry conditions a greater quantity of rainfall or irrigation may be required for effective activation of the product. Under these conditions, shoots of germinating weeds may intercept the RELYON ISOXAFLUTOLE 750 WG HERBICIDE band and appear affected, but may not be controlled. Weeds that DO NOT turn completely white within days of emergence must be sprayed with an appropriate knockdown herbicide. To avoid weed escapes, it is recommended to allow weeds to germinate, and then apply RELYON ISOXAFLUTOLE 750 WG HERBICIDE in tank mixture with Paraquick 250 Herbicide at an appropriate label rate to provide additional weed knockdown. Soil movement from irrigation or cultivation may result in poor weed control from RELYON ISOXAFLUTOLE 750 WG HERBICIDE. DO NOT incorporate RELYON ISOXAFLUTOLE 750 WG HERBICIDE by flood irrigation or with high-pressure water cannons if excessive soil movement is expected, particularly if the soil is in a loose, dry condition. Best results are achieved where rainfall or low pressure overhead irrigation carries the herbicide downward in an even band to the depth of the weed root zone.

Compatibility:

Sugarcane: RELYON ISOXAFLUTOLE 750 WG HERBICIDE may be tank-mixed with Paraquick 250 Herbicide formulations at the appropriate label rates for each product. RELYON ISOXAFLUTOLE 750 WG HERBICIDE may be tank-mixed with Harrow 900WG Herbicide (Diuron) at the rate recommended in the 'Directions For Use' table on this label. RELYON ISOXAFLUTOLE 750 WG HERBICIDE is also compatible with Atrizon 900WG Herbicide (atrazine ) and Actril® DS (apply no more than 500 mL/ha in combination with RELYON ISOXAFLUTOLE 750 WG HERBICIDE). *Actril® is Registered Trademarks of Bayer.

Chickpeas: RELYON ISOXAFLUTOLE 750 WG HERBICIDE should NOT be tank-mixed with trifluralin.

Spray Equipment Clean-up:

To avoid injury or exposure to non-target crops, thoroughly clean all mixing and spray equipment, including pumps, nozzles, lines and screens with a good quality tank cleaner immediately after using RELYON ISOXAFLUTOLE 750 WG HERBICIDE. Before disassembling nozzles, filters and other parts for cleaning, thoroughly wash down the exterior of the spray equipment with a pressure hose. A more rigorous cleaning process is recommended, particularly before spraying very sensitive crops (e.g. canola). To Rinse: After cleaning the tank as above, quarter fill the tank with clean water and circulate through the pump, lines, hoses and nozzles. Drain and repeat the rinsing procedure twice. To Clean: Empty the tank completely and drain the whole system. Without entering it, thoroughly wash inside the tank using a pressure hose. Alternatively, if the tank is fitted with in-tank rinse nozzles, activate these nozzles to thoroughly rinse the inside of the tank. Drain the tank and clean any tank, pump, line and nozzle filters. To Decontaminate: Quarter fill the tank and add a liquid alkali detergent at 500 mL/100 L of water or a chlorine bleach (4% chlorine) at 300 mL/100 L of water and circulate throughout the system for at least 15 minutes. Drain the whole system. Nozzles, screens, relief valves, dump lines, caps and taps at the end of spray lines, tank lids, flow meters, lines to pressure gauges, external tank indicators, induction hoppers and transfer systems should be removed/pulled apart and cleaned separately. Pay special attention to by-pass lines from pressure relief or dump valves to the main tank. To remove traces of chlorine bleach, flush the system with clean water and allow to drain. Rinse Water Should Be Discharged Onto A Designated Disposal Area Or If This Is Unavailable, Onto Unused Land Away From Desirable Plants And Their Roots, And Water Courses.