Sulphur 800 WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS:

Fungicide Resistance Warning:

• The product is a Group M2 fungicide.
• Resistant fungi may exist due to genetic variability. Continuous use of this product and other Group M2 fungicides may lead to resistance.
• Kenso Corporation (M) Sdn. Bhd accepts no liability for losses resulting from the failure of the product to control resistant fungi.

MIXING:

• Premix the required amount in a small quantity of water.
• Half-fill the spray tank and start agitation.
• Slowly add the well-stirred premix.
• Top up with the required quantity of water.
• Maintain agitation throughout the spraying procedure.

Application in Tree Crops and Vines:

DILUTE SPRAYING:

• Use a sprayer designed for high water volumes up to the point of runoff, matched to the crop.
• Set up the sprayer for even coverage throughout the crop canopy.
• Apply enough water to cover the crop to the point of runoff, avoiding excessive runoff.
• Adjust water volume based on industry guidelines, expert advice, or test volumes.
• Add the product according to the Directions for Use table (amount per 100L of water).

CONCENTRATE SPRAYING:

• Use a sprayer designed for concentrate spraying (applies less water than needed for runoff) matched to the crop.
• Achieve even coverage throughout the crop canopy with your chosen water volume.
• Determine an appropriate dilute spray volume for the crop canopy (See Dilute Spraying above) to calculate the concentrate mixing rate.
• Calculate mixing rate: Concentration factor x dilute label rate.
  • Example: Dilute spray volume 1500L/ha, concentrate spray volume 500L/ha, dilute label rate 10 mL/100 L.
  • Concentration factor = 3 (1500L ÷ 500L), concentrate rate = 3 x 10 = 30mL/100L.
• Adjust spray volume, product amount per 100L, and sprayer setup as the crop grows.
• Consult industry guidelines, undergo training, and follow best practices for concentrate spraying.

COMPATIBILITY:

• Compatible with most commonly used fungicides and insecticides.
• Mixing preparations is at the user's risk, and neither the manufacturer nor seller assumes responsibility.
• Conduct a preliminary test with small quantities before use.
• DO NOT mix with dinitrophenol derivatives (e.g., DNOC) or oil-containing products.
• DO NOT apply tank mixes to stressed crops.