Tralkoxydim 400 WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE

RESTRAINTS DO NOT apply to weeds or crops under stress due to severe frost, drought, water logging, low soil fertility, pre -emergent herbicides, insects or diseases.
DO NOT use boomless jets or misters.
DO NOT apply if rain is expected within a half-hour.

Mixing
Only use sprayers in good working condition with high capacity agitation. Ensure the sprayer is cleaned according to the label instructions on the product used prior to Tralkoxydim WG. Use only clean water for the spray solution. Ensure that all in-Iine strainer and nozzle screens in the sprayer are 100 mesh or coarser. Do NOT use cartridge or disc filters after the spray tank outlet, or have two (or more) filters directly after each other anywhere in the system. Begin to fill spray tank with clean water, and engage agitator. Agitation must be continued throughout the entire mixing and spraying procedure. When the sprayer is half full of water, add Tralkoxydim WG slowly to the spray tank through the tank opening or through a hopper designed to handle granules. The hopper should be dry before adding Tralkoxydim WG granules. • Do not premix Tralkoxydim WG. • Add the total required amount of Tralkoxydim WG from all cartons first, prior to adding other herbicides or Supercharge adjuvant. • Wait at least one minute after the last of the Tralkoxydim WG has been added to the tank to allow for complete dispersion of the granules. • Add the recommended broadleaf weed herbicide or insecticide next if tank mixing. • Slowly add Supercharge to the tank last, in at least 10 times its volume of water especially where a suction (filling) probe or hopper is used. • Continue to fill tank to desired level with water.

Spraying instructions

Ground equipment Apply in a spray volume of 50-150 litres of water per hectare at a pressure of 250-350 kPa to ensure proper dispersion and spraying characteristics of the Tralkoxydim WG spray mix. Use flat fan nozzles such as Spraying Systems 110-01, 110-015, 110-02 or equivalent sizes from other manufacturers. Do not use 110-03 or bigger nozzles with Tralkoxydim. Do not use floodjet nozzles, boom less jets or misters or controlled droplet application equipment. Nozzles may be angled forward 45° to enhance penetration of the crop and provide better coverage. Always ensure that agitation is continued until spraying is completed even if stopped for brief periods of time. If the agitation is stopped for more than 5 minutes re-suspend the spray solution by running on full agitation until the settled particles are fully re-suspended, prior to spraying. The spray mixtures of Tralkoxydim WG and Supercharge may be left overnight without loss of efficacy provided the settled product is completely re-suspended by stirring and/or agitation prior to re-use.

Aerial equipment

Apply through boom or Micronair units in 20-30 litres of water per hectare. The use of the higher volume is preferred due to more reliable results. Droplet size should be 200-250 microns (VMD) and swath width should not be wider than recommended for type of plane and application unit. Weed control following aerial application may not be as good as from ground application.