Victory 600Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

MIXING

Tank-mixing: The following order should be followed:

1. Fill the spray tank to 70% full and commence agitation.

2. Add any wettable powders, water dispersible granules, or dry flowable formulations with continuous agitation, ensure the product is completely dissolved/dispersed before proceeding.

3. Add suspension concentrates followed by dispersible concentrates then suspo-emulsions.

4. Add emulsifiable concentrates including selective grass herbicides or other broadleaf herbicides.

5. Fill the tank to nearly full.

6. Add VICTORY 600 and other soluble liquids.

7. Add Uptake† Spraying Oil or Wetspray 1000.

8. Add water to bring to the final spray volume.

Only mix sufficient spray solution for immediate use and avoid storing.

COMPATIBILITY

Conventional Canola: VICTORY 600 + Uptake† Spraying Oil or an equivalent mineral oil + surfactant mix are compatible and selective.

Triazine Tolerant Canola: Farmozine + VICTORY 600 + Firepower / Firepower 900 + Uptake† Spraying Oil or an equivalent mineral oil + surfactant mix are compatible and selective.

Clearfield Canola: Intervix† + VICTORY 600 are compatible and selective.

VICTORY 600 is compatible with the following:

Broadleaf Herbicides: Adama 2,4-D Amine, Artillery, Bronco 400, Bronco MA-X, Cavalier 500, Colt, Adama Diuron 900 WG, Eclipse†, Adama MCPA LVE 570, Ecopar†, Eliminar C†, Elevate, Enforcer 242, Excalibur IVM, Farmozine 900 WG, Flagship 400, Flight EC†, flumetsulam, Legacy MA, Adama LVE MCPA 570, Lynx WG, MCPA 750, Mentor, metsulfuron-methyl, Paradigm™, Picoflex, Precept†, Quadrant, Safari 750, Simanex WG, Spray.Seed†, Spraytop 330, Stinger†, sulfometuron methyl, Tackle WG, terbacil/sulfometuron methyl, Terbutrex, Triathlon, Velocity†, and Zulu XT.

GRASS HERBICIDES ON BROADLEAF CROPS: Farmozine WG, Firepower, Intervix†, Platinum Xtra 360, and Simanex 900 WG.

GRASS HERBICIDES IN CEREAL CROPS: Atlantis† OD, Countdown, Crusader†, diclofop methyl, Hussar†, Inego 100 EC, Mandate, Mandate XTRA, Monza†, and Pentagon 400 WG.

BROAD SPECTRUM HERBICIDES: Adama Diuron 900 WG, Spray.Seed†, Spraytop 250, Spraytop 330, Wipe-Out 450, and Wipe-Out Pro.

ADJUVANTS: Wetspray 1000, Uptake† Spraying Oil or an equivalent mineral oil + surfactant mix, and Pulse†.

Forestry: Please consult with Adama Australia for tank-mix partners.

APPLICATION

Droplet VMD should be of coarse spray quality according to the ASAE S572 definition for standard nozzles. Use a nozzle type that is designed for the intended application.

Ground Application

Apply in 50 to 100 L water/ha through accurately calibrated equipment.

Hardhead thistle – Apply in 200 to 250 L/ha of water.

Silver wattle – Apply in 150 to 200 L/ha of water.

Aerial Application

Apply in not less than 20 L water/ha through accurately calibrated equipment. DO NOT use less than 50 L/ha for Silver wattle.

Motorised High Volume Hand Gun

Apply the recommended mix to give full coverage of leaves and stems through a No. 6-8 tip at 700 to 1500 kPa. The spray volume for effective coverage of dense two-meter-high Silver wattle should be 30 to 40 liters of spray per 100 m2 of infestation. For larger areas, an equivalent would be 3000 to 4000 liters per infested hectare.

Stem Injection

To make a stem injection pocket at waist height, use a 3/4 length axe with a blade of 5-7 cm. The axe cut must be through the bark and deep enough to place all the chemical in contact with the sapwood.

The chemical must be applied immediately after the injection pocket is made. Apply the chemical with a Phillips 5 mL vaccinator fitted with a tree injector kit which can be accurately calibrated. Set vaccinator to deliver 1 mL of the diluted mix.

When treating regrowth less than the width of the axe, ensure the chemical does not run out the sides of the cut, as reduced control will result. This can be overcome by using the corner of the axe to make the pocket in the stem.

CLEANING SPRAY EQUIPMENT

Rinse water should be discharged onto a designated disposal area or, if this is unavailable, onto unused land away from desirable plants and water courses.

Partial cleaning (before spraying other labeled or tolerant crops):

After using VICTORY 600, empty the tank completely and drain the whole system. Thoroughly wash inside the tank using a pressure hose. Quarter fill the tank with clean water and circulate through the pump, line, hoses, and nozzles. Drain and repeat the procedure twice.

Complete cleaning (before spraying crops that are susceptible to residues of VICTORY 600):

After using VICTORY 600, empty the tank completely and drain the whole system. Thoroughly wash inside the tank using a pressure hose. Quarter fill the tank with clean water and circulate as above, then drain. Quarter fill the tank again and add a liquid alkali detergent at 500 mL/100 L water and circulate throughout the system for at least 15 minutes. If using concentrated laundry detergent use 250 g (or mL)/100 L water. Do not use chlorine-based cleaners. Drain, remove filters and nozzles and clean separately. Rinse inside the tank thoroughly using a pressure hose and flush the system with clean water.

These tank cleaning recommendations are for VICTORY only. Please consult tank mix partner labels to determine requirements for decontamination. Rinse water should be discharged onto a designated disposal area or, if this is unavailable, onto unused land away from desirable plants and water courses.