Wynca Glyphosate 360Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

PRODUCT INFORMATION Wynca Glyphosate 360 Weedkiller is translocated throughout the plant, targeting both foliage and roots. It is most effective during active growth, moderate climatic conditions, and when plants are disease-free and free of dirt cover. Symptoms typically appear 2-7 days after spraying annual species and 2-3 weeks after spraying perennial species. Symptoms include yellowing, wilting, and eventual browning.

SAFETY TO CROPS

• Do not allow contact with desirable crops, plants, or trees as the chemical is non-selective.
• Avoid spraying when wind is directed towards desirable plants.
• Use coarse droplet settings in calibration (avoid 150 micron or less).
• Avoid spraying in winds over 8 km/hr, still air, and hot days.
• Sowing can commence from one day after spraying in light weed presence.
• For heavy weed cover, allow decay before sowing for a suitable seedbed.

SPRAY PREPARATION

1. Ensure a clean tank without residues from previous use.
2. Half-fill the tank with clean water, avoiding soil-contaminated or hard water.
3. Add the specified amount of product per Directions for Use.
4. Mix well, keeping the filling hose below the surface to prevent foaming.
5. Add water to fill the vat.
6. Remove the hose promptly to prevent back siphoning.

• Do not use mechanical agitators to avoid excessive foaming.
• Do not add non-approved herbicides and insecticides.
• Use only approved containers (plastic, plastic-lined, stainless steel, aluminum, brass, copper, or fiberglass). Avoid galvanized or unlined steel containers.

SURFACTANT

• The addition of a surfactant may enhance weed control, especially with high water rates or low product rates.
• Recommended surfactant rates: 200 mL/100 L of 1000 g/L non-ionic surfactant or 250-500 mL/100 L of 700 g/L surfactant.
• Do not add oils, agricultural chemicals, or any other materials not directed on the label.

ORGANOSILICONE PENETRANT

• In specific situations (as indicated in the Directions for Use table), adding an organosilicone penetrant (200 mL/100 L spray solution) may enhance weed control.

RAINFALL EFFECTS

• Heavy rain within 2 hours of spraying may wash off the chemical, requiring potential re-spraying.
• Normal rain within 6 hours may reduce effectiveness.
• Avoid application during stressful seed conditions (drought, waterlogging, frost).

SOIL PERSISTENCE

• Not persistent in soils, rapidly broken down by soil microbes and hydrolysis.
• Refer to the Compatibility section if residual activity is needed.

RESISTANT WEEDS WARNING

• Wynca Glyphosate 360 Weedkiller is a Group M herbicide.
• Resistance management is crucial. Continuous use may lead to resistant weed populations.
• No liability accepted for losses due to failure in controlling resistant weeds.

APPLICATION EQUIPMENT

• HIGH VOLUME APPLICATION (e.g., knapsack/handgun equipment):

  • Use D6 spray tip or equivalent at 400-700 kPa pressure.
  • Good coverage is essential for maximum uptake.

• BOOM EQUIPMENT:

  • Use fan nozzles at 240-280 kPa pressure. Water volumes vary but should not exceed 200 L/ha.

• AERIAL EQUIPMENT:

  • Use Micronair and boom equipment with a droplet size of 250-350 microns.
  • Swath width: 15-17 meters. Minimum spray volume: 15 L/ha.
  • Adjust water volume and droplet size based on terrain and temperature.

• WIPER EQUIPMENT:

  • Follow manufacturer guidelines. As a general guide, mix 500 mL with 1 L of water.
  • Apply when weeds are 15 cm above the crop, at speeds not exceeding 8 km/hr.
  • Mix enough solution for immediate use; do not store for more than a couple of days.

• LOW VOLUME APPLICATION (e.g., Gas Gun or Splatter Gun):

  • Apply an even spray to cover all foliage. Refer to the label for specific dilution and volume recommendations.