Xentari WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

XenTari WG Bta consists of specially prepared water dispersible granules containing live spores and endotoxin of a naturally occurring bacterium. This granule is mixed with water before application and can be applied through any standard spray equipment. XenTari WG controls the larvae (caterpillar stage) of certain important insect pests that attack crops. XenTari WG Bta is toxic only to caterpillars of certain Lepidopterous insects (moths and butterflies). It does not harm beneficial insect and mite predators and leaves no harmful crop residues. XenTari WG Bta stops caterpillars feeding almost immediately but does not kill them immediately. This protects the crop from further damage. However, the non-feeding caterpillars may be seen on the plant before falling off, normally within 3 to 4 days.

INSECTICIDE RESISTANCE WARNING

For insecticide resistance management, XenTari WG Bta is a Group 11 insecticide. Some naturally occurring insect biotypes resistant to XenTari WG Bta and other Group 11 insecticides may exist through normal genetic variability in any insect population. The resistant individuals can eventually dominate the insect population if XenTari WG Bta or other Group 11 insecticides are used repeatedly. The effectiveness of XenTari WG Bta on resistant individuals could be significantly reduced. Since occurrence of resistant individuals is difficult to detect prior to use, Valent BioSciences or Sumitomo Chemical Australia Pty Ltd accepts no liability for any losses that may result from the failure of XenTari WG Bta to control resistant insects. XenTari WG Bta may be subject to specific resistance management strategies. For further information contact your local supplier, Sumitomo Chemical Australia Pty Ltd representative or local agricultural department agronomist.

MIXING

Add the required quantity onto the surface of the water in the partially filled tank. Agitate thoroughly and add the remainder of water, continue agitation until fully mixed, and maintain the suspension with agitation while mixing and spraying. Use spray within 12 hours of mixing. Addition of a non-ionic wetting agent at label rates assists coverage, particularly on waxy surfaces.

APPLICATION

As this product must be ingested, thorough spray coverage is essential to give uniform deposit of XenTari WG Bta at the site of larval feeding. If rain falls shortly after treatment, re-treatment may be necessary. To achieve the best control, apply XenTari WG Bta before crop damage occurs, when pest population is beginning to build and larvae are starting to hatch. Avoid waiting until populations have begun to damage crop and the infestation is “out of control”. XenTari WG Bta should not be used on “out of control” populations. Use overhead and drop nozzles to obtain good coverage on both sides of foliage, using sufficient spray volume to ensure a uniform deposit on all plant surfaces. The water volume will depend on crop stage, humidity, spray equipment, and local experience. Usually, the selection of moderate to high spray volumes will provide the best results with most equipment. To obtain maximum assistance from beneficial insects, avoid use of broad-spectrum insecticides during a program of XenTari WG Bta sprays.

COMPATIBILITY

XenTari WG Bta is compatible with most insecticides and fungicides. DO NOT apply as a tank mix with, or within 2 days of application of alkaline products such as Bordeaux mixtures.

PROTECTION OF WILDLIFE, FISH, CRUSTACEANS AND ENVIRONMENT

DO NOT contaminate ponds, waterways, and drains with this product or used containers. Controls cabbage moth (diamondback moth), cabbage white butterfly, cabbage-centre grub, and cabbage cluster caterpillar in cole crops as specified in the Directions for Use table.

STORAGE AND DISPOSAL

Keep out of reach of children. Store below 25°C (Air conditioning). Store in the closed, original container in a well-ventilated area out of direct sunlight. DO NOT store for prolonged periods in direct sunlight. Rinse containers before disposal. Add rinsings to spray tank. DO NOT dispose of undiluted chemicals on-site. Dispose of at a local authority landfill. If not available, bury the containers below 500 mm in a disposal pit specifically marked and set up for this purpose clear of waterways, vegetation, and roots. Empty containers and product should not be burnt.

SAFETY DIRECTIONS

Will irritate the eyes and skin. Avoid contact with eyes, skin, and open wounds. DO NOT inhale spray mist. When preparing spray and using the prepared spray, wear cotton overalls buttoned to the neck and wrist and a washable hat, elbow-length PVC gloves, and a face shield or goggles. If product on skin, immediately wash the area with soap and water. If product in eyes, wash out immediately with water. After use and before eating, drinking, or smoking, wash hands, arms, and face thoroughly with soap and water. After each day's use, wash gloves and face shield or goggles and contaminated clothing.