Bravo ZNCPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

PRODUCT INFORMATION

BRAVO ZN Agricultural Fungicide is an excellent fungicide when used according to label directions for control of a broad spectrum of plant diseases. BRAVO ZN Agricultural Fungicide can be used effectively in dilute or concentrate sprays. Thorough uniform coverage is essential for disease control.
DO NOT combine BRAVO ZN Agricultural Fungicide in the spray tank with pesticides, surfactants or fertilizers, unless your prior use has shown the combination physically compatible and non-injurious under your conditions of use. Note: Slowly invert container several times to assure uniform mixture.
The required amount of BRAVO ZN Agricultural Fungicide should be added slowly into the spray tank during filling. With concentrate sprays, premix the required amount of BRAVO ZN Agricultural Fungicide in a clean container and add to the spray tank as it is being filled. Keep agitator running when filling spray tank and during spray operations.

DIRECTIONS FOR USE
General Information
As this product is not registered for the control of pests in aquatic systems, DO NOT use to control aquatic pests.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
DO NOT use on greenhouse-grown agricultural crops, with the exception of celery seedbeds.
DO NOT allow effluent or runoff from greenhouses and mushroom houses containing this product to enter lakes, streams, ponds or other bodies of water.
Dosage rates on this label indicate litres of BRAVO ZN Agricultural Fungicide per hectare, unless otherwise stated. Applications should be made in sufficient water to obtain adequate coverage of foliage. Volume of water to be used will vary with crop and amount of plant growth. Spray volume usually will range from 225-1,600 litres per hectare for dilute sprays and 50-100 litres per hectare for concentrate ground sprays and aircraft applications. Both ground and aircraft methods of application are recommended unless specific directions are given for a crop.

Ground Application
General Precautions
Mixers and loaders must use a closed system.
Wear coveralls over a long-sleeved shirt and long pants, chemical-resistant gloves, socks and shoes during mixing, loading, application, clean-up and repair.
Applicators treating potato fields must use groundboom equipment with an enclosed cab. Gloves are not required for an application in an enclosed cab. Wear chemical-resistant gloves when leaving the cab for clean-up and repair.
Field sprayer application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply with spray droplets smaller than the American Society of Agricultural and Biological Engineers (ASABE) medium classification. Boom height must be 60 cm or less above the crop or ground.

Mixing Instructions
1. Ensure that the sprayer interior is clean, then fill the spray tank with ½ the required amount of water and engage gentle agitation. Good agitation is indicated by a rippling or rolling action on the surface of the water.
2. Add any WG or DF formulation mix partners and agitate to ensure complete mixing.
3. Add BRAVO ZN (SC) and agitate to ensure complete mixing.
4. Add any additional SC formulation mix partners and agitate to ensure complete mixing.
5. Add any EC formulation mix partners and agitate to ensure complete mixing.
6. Fill the tank to ¾ the required amount of water.
7. Add any solution (SN) formulation mix partners and agitate to ensure complete mixing.
8. Finish filling the sprayer with water, maintaining good agitation.
9. After any break in spraying operations, agitate thoroughly before spraying again.
10. Spray the pesticide suspension the same day as mixing.
11. Do not mix, load or clean spray equipment where there is a potential to contaminate wells or aquatic systems.
NOTE: WG and DF formulations are preferentially batch mixed.
NOTE: SC, SN, and SL formulations may be inducted or batch mixed.
NOTE: EC formulations are preferentially batch mixed.

Spraying Instructions
1. Water Volume: Specific to crop and disease. Consult the tabulated instructions for use which follow.
2. Spray Nozzles: 80° or 110° pre-orifice flat fan or air induction nozzles are recommended.
Use 50 mesh nozzle screens. Do not use flood type nozzles, controlled droplet application equipment, spray foils or hollow cone nozzles.
3. Pressure: As recommended by the nozzle manufacturer.
4. Apply at uniform speed and avoid overlapping. Shut off spray boom while starting, turning, slowing or stopping to avoid potential crop injury from over application.