Carzol SP Instapack

Registered until
Registration number
Active materials

1. Do not reuse container.
2. Make the empty container unsuitable for future use.
3. Dispose of the container in accordance with provincial requirements.
For information on the di sposal of un used, unwanted product, contact the manufa cturer or the provincial regul atory agency. Contact the manufacturer and the provincial regulatory agency in case of a spill, and for clean-up of spills.

Do not subject to temperatures below 0 C. At temperatures below 0 C, soluble film packaging becomes susceptible to cracking and breakage. Store in a cool, dry place. Do not store at temperatures above 40 C. To prevent contamination, store product in original container only, away from other pesticides, fertilizer, food or feed.

CARZOL SP Instapak is packaged in a WSB that is to be dropped into the spray tank unopened.
DO NOT apply this product directly to freshwater habitats (such as la kes, rivers, sloughs, ponds, coulees, prairie potholes, creeks, marshes, streams, reservoirs, ditches and wetlands), estuaries or marine habitats.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty.

R.E. Airblast or Mist blower application:
DO NOT direct spray above plants to be treated. Turn off outward pointing nozzles at row ends and outer rows. DO NOT apply when wind speed is greater than 16 km/h at the appl ication site, as measured outside of the treatment area on the upwind side.
DO NOT apply this product by aircraft.
The buffer zones specified in the table below are required between the point of direct a pplication and the closest downwind edge of sensitive freshwater habitats, (such as lakes, rivers, slo ughs, ponds, prairie potholes, creeks, marshes, streams, reservoirs and wetlands) and estuarine/marine habitats.
When a tank mixture is used, consult the labels of the tank-mix partners and observe the largest (most restrictive) buffer zone of the products involved in the tank mixture.

The enclosed WSB containing CARZOL SP Instapak is water soluble. Do not allow the WSB to become wet prior to adding the spray tank. Do not handle with wet hands.
WARNING: Ensure that the spray tank, pump and li nes are clean and do not contain bo ron or any substances releasing free chlorine. Any boron or free chlorine will cause incomplete dissolution of the water-soluble film which will result i n plugging of the sprayer pump, lines, or screens.
Half fill the spray tank with water (see WARNING above). With agitator operating, add the desired number of 1.1 kg WSB. Do not exceed the maximum label rate. If there is a screen in the fill opening, place WSB on the screen and direct water flow onto them. Do not cut open the WSB. Add balance of water to fill tank. Operat e the agitator while mixing. Depending on the water temperature and the degree of a gitation, the WSB should be compl etely dissolved within approximately 5 to 10 minutes from the time they were added to the water. Do not use WSB in a tank-mix with products that contain boron or release free chlorine.
CARZOL SP Instapak is completely soluble in water. It is not stable in alkaline water. Prepare the spray mixture just before application and spray entire contents of tank within 4 hours. CARZOL SP In stapak is compatible with most commonly used insecticides and fungicides except lime and Bordeaux mixture. The WSB of CARZOL SP Instapak must be added to the spray water and the WSB film must be completely dissolved before any other products are added.
Crop: Nectarine
Insect: European Red Mite, Two-Spotted Spider Mite
Method: Use sufficient water for good coverage. Direct nozzles of air blast sprayer into the targeted tree orchard when spraying the border rows. DO NOT apply when the prevailing wind direction will cause drift from treated areas into lakes, ponds and other waterways. When using concentrate spray, apply same quantity of CARZOL SP Instapak per hectare as for dilute spray.
Nectarines: Pesticid e products containing the active ingre dient formetanate hydrochloride should not b e applied aft er petal fall. Late season applications are not permitted. The majority of the mite population should be in the young nymphal stage.
Rate: Use 275-350g product per 1000L of dilute spray (4000-5000L of water per hectare). 
DO NOT exceed 1.4 kg product/ha for all crops.
DO NOT apply more than once per growing season.

Registered for culturesRate
Nectarines1.1 - 1.4 kg