Clayton BonsaiPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE.

IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.

Restrictions/Warnings
Failure to comply with label recommendations may result in reduced activity or crop damage. Small scale testing of any rose variety is recommended at all crop stages before use to establish its tolerance under the conditions of use. Allow sufficient time for symptoms to develop.

Crop-specific information
Clayton Bonsai has been shown to have no effect on fruit quality or fruit finish.
Apples and pears : Time and rate of application.
For the control of fruit tree red spider mite apply Clayton Bonsai at a rate of 500g/ha in a spray volume of 250 to 2000 litres of water/ha. Apply before the pest becomes established.
Applications must not be made before 90% petal fall.Consult your adviser for current mite treatment thresholds. Moderate control of apple rust mite can be achieved from applications made against fruit tree red spider mite in apples.
The in-use spray concentration must not exceed 200 g product per 100 litres water.
Maximum dose per year: 500g product/ha.
DO NOT APPLY LATER THAN 7 days before harvest.

Mixing and Spraying
One third fill the tank with water. Start agitation. Open the re-sealable pack and remove with dry gloves the required number of water soluble bags. Add the bags to the tank and allow them to disperse. Re-seal the pack, if there are any water soluble bags left in the pack. DO NOT OPEN BAGS. If tank-mixing, add the other product(s) only if Clayton Bonsai has fully dispersed. Fill the tank. Maintain agitation whilst spraying.

Spraying
Due to the size of the water soluble sachet, Clayton Bonsai should not be used in knapsack sprayers.
DO NOT REMOVE INNER LINER.