Converge 480

Manufacturer
BAYER
Category
Herbicides
Registered until
2024-12-31
Registration number
26277
Active materials
Links

FOR SELECTIVE WEED CONTROL IN FIELD CORN
DO NOT USE IN THE PROVINCE OF BRITISH COLUMBIA

GROUND APPLICATION:
Do not apply Converge 480 Herbicide at rates greater than 2.22 L/ha. This product is used only in tank mix applications listed on this label. Refer to the tank mix partners listed on this label for complete instructions.
DO NOT APPLY BY AIR
STORE IN A DRY PLACE
Bulk sites must be diked around and under the bulk tank with an impermeable non-earthen dike. The dike must be large enough to hold and contain 110 percent of the capacity of the largest tank.
CAUTION: Do not graze treated immature crops or cut for fodder. In the case of corn, immature means before ear emergence. Sufficient data are not available to support such use. Do not harvest within 60 days of application on field corn.

DIRECTIONS FOR USE:
CONVERGE 480 Herbicide provides selective control of broadleaf weeds and wild oats in corn.

TIMING OF APPLICATION:
Can be applied pre-plant surface or after planting but prior to crop emergence in either conventional tillage or minimum tillage programs.

CONSULT TANK-MIX PARTNER LABELS FOR COMPLETE INSTRUCTIONS AND RESTRICTIONS, ALWAYS USE MOST RESTRICTIVE DIRECTIONS ON TANKMIX PARTNER LABELS OF THE TANK MIX USED.

MIXING AND SPRAYING INSTRUCTIONS:
Protect sprayer operators from drift or mist. Additional information on spray drift management for GROUND APPLICATION is provided in the section “SPRAY DRIFT MANAGEMENT FOR GROUND APPLICATIONS”. When low volumes of spray are applied, complete coverage and thorough application are essential for the most effective results. Schedule applications in accordance with local conditions. Consult your local agricultural authorities for specific use information. Where possible, use a nurse tank to fill your spray tank.
Mixing Steps:
(1) Spray equipment should be thoroughly flushed with clean water before mixing CONVERGE 480 Herbicide.
(2) Fill tank 3/4 full with carrier and add the CONVERGE 480 Herbicide and other liquid products if applicable.
(3) Finish filling tank. Maintain gentle agitation during mixing and spraying operations.
(4) Do not let stand without agitation.
- Spray pressure 200 - 300 kPa
- Spray volume - minimum 150 litres per hectare
- Use 16 mesh suction screen. 50 mesh screens elsewhere on sprayer.

DO NOT apply tank mixes to field corn grown on loamy sands or sands and/or soils with less than 2 % O. M.

CONSULT TANK-MIX PARTNER LABELS FOR COMPLETE INSTRUCTIONS AND RESTRICTIONS
Do NOT apply by air.
Do NOT apply during periods of dead calm or when winds are gusty.
Do NOT overspray non-target terrestrial or aquatic habitats.
Do NOT contaminate aquatic habitats when cleaning and rinsing spray equipment or containers.
When a tank mixture is used, consult the labels of the tank-mix partners and observe the largest (most restrictive) buffer zone of the products involved in the tank mixture.
A firm, level seedbed free from large clumps and surface trash must be prepared to ensure uniform weed control.
Do not use CONVERGE 480 Herbicide on loose and rough seedbeds.

Registered for culturesRatePreharvest Interval
Corn2.22 l60