Cyazofamid 400 SC AgriculturalPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE

Cyazofamid 400SC Fungicide can be used in dilute sprays. Thorough, uniform coverage is essential for disease control.
NOTE: Slowly invert container several times to assure uniform mixture.
Dosage rates on this label indicate litres of Cyazofamid 400SC Fungicide per hectare.
Apply Cyazofamid 400SC Fungicide in sufficient water volume to obtain coverage of the foliage. Spray volume to be used will vary with the amount of plant growth and will range from 200 to 600 litres per hectare unless specified otherwise. For all foliar applications, Cyazofamid 400SC Fungicide should be tank-mixed with a non-ionic or organosilicone surfactant (such as Sylgard 309) at the manufacturer’s label recommendations.
The required amount of Cyazofamid 400SC Fungicide should be added slowly into the spray tank during filling. Keep agitator running when filling spray tank and during spray operations.
Since pathogens differ in their potential to develop resistance to fungicides, follow the directions outlined in the “Directions For Use” section of this label for specific resistance management strategies. Consult with your provincial agricultural authorities for guidance on the proper use of Cyazofamid 400SC Fungicide in programs that seek to minimize the occurrence of disease resistance.
Airblast application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT direct spray above plants to be treated. Turn off outward pointing nozzles at row ends and outer rows. DO NOT apply when wind speed is greater than 16 km/h at the application site as measured outside of the treatment area on the upwind side.
Field sprayer application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) medium classification. Boom height must be 60 cm or less above the crop or ground.
Aerial application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply when wind speed is greater than 16 km/h at flying height at the site of application. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) medium classification. To reduce drift caused by turbulent wingtip vortices, the nozzle distribution along the spray boom length MUST NOT exceed 65% of the wing- or rotorspan.
As this product is not registered for the control of pests in aquatic systems, DO NOT use to control aquatic pests.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
DO NOT allow effluent or runoff from greenhouses containing this product to enter lakes, streams, ponds or other waters.
DO NOT apply using fogging or ultra low volume equipment.
DO NOT apply using handheld mistblowers or handheld airblast equipment.

DIRECTION FOR USE: AERIAL APPLICATION – CUCURBITS AND POTATOES ONLY
Apply only by fixed-wing or rotary aircraft equipment which has been functionally and operationally calibrated for the atmospheric conditions of the area and the application rates and conditions of this label.
Label rates, conditions and precautions are product specific. Read and understand the entire label before opening this product. Apply only at the rate recommended for aerial application on this label. Where no rate for aerial application appears for the specific use, this product cannot be applied by any type of aerial equipment.
Ensure uniform application. To avoid streaked, uneven or overlapped application, use appropriate marking devices.
Cyazofamid 400SC Fungicide may be applied by air to cucurbits ONLY if ground equipment cannot be used due to flooded field conditions.