Daconil UltrexPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Turf and Ornamental Fungicide

DECONTAMINATION AND DISPOSAL
For information on disposal of unused, unwanted product, contact the manufacturer or the provincial regulatory agency. Contact the manufacturer and the provincial regulatory agency in case of a spill, and for clean up of spills.

BAG DISPOSAL:
1. Empty bag thoroughly into spray tank.
2. Make the empty bag unsuitable for further use.
3. Dispose of the bag in accordance with provincial requirements.

PRODUCT INFORMATION
A BROAD SPECTRUM FUNGICIDE FOR USE ON GOLF COURSE GREENS, TEES, AND FAIRWAYS, ORNAMENTAL TURFGRASS AND ORNAMENTALS. Read entire label carefully and use only as directed.
ACONIL Ultrex Fungicide is formulated for use on golf course greens, tees, and fairways, ornamental turfgrass and ornamental herbs, shrubs and trees. It is highly effective for the control of a broad spectrum of turf and ornamental plant diseases when it is used according to the directions on this product label. Thorough, uniform coverage of plant surfaces is essential for good disease control.
DACONIL Ultrex Fungicide is recommended for use in programs which are compatible with the principles of Integrated Pest Management (IPM), which include the use of disease resistant crop varieties, cultural practices, pest scouting and disease forecasting systems which reduce unnecessary applications of pesticides.

Mixing Instructions
Apply DACONIL Ultrex Fungicide as a spray, using sufficient water to obtain adequate coverage of plant surfaces. Volume of spray to be used may vary, depending on crop and plant growth, from 200 to 4,000 liters per hectare for dilute sprays, and 50 to 100 liters per hectare for concentrate sprays. Use the higher spray volumes when foliage is dense and coverage is more difficult. In a typical golf course application, volume of spray to be used is 400 to 2000 litres per hectare.
Add the required amount of DACONIL Ultrex Fungicide to the spray tank while filling with water. Keep agitator running when filling spray tank and during spray operations.
DO NOT combine DACONIL Ultrex Fungicide in the spray tank with pesticides, surfactants or fertilizers unless your prior use has shown the combination physically compatible, effective and non injurious under your conditions of use.
DO NOT APPLY BY AIR

DIRECTIONS FOR USE
Sod farm turf treated with Chlorothalonil prior to harvest must be mechanically cut, rolled and harvested.
This product is not to be used around homes or other residential areas such as parks, school grounds, playing fields. It is not for use by homeowners or other uncertified users. Do not apply this product in a way that will contact workers or other persons or pets either directly or thorough drift. Only protected handlers may be in the area during application.
Turf: DO NOT mow or water after treatment until spray deposit on turfgrass is thoroughly dry; DACONIL Ultrex Fungicide should always be used in conjunction with good turf management practices.
On Golf Course Tees, Greens, Fairways and Ornamental Turfgrass:
Apply DACONIL Ultrex Fungicide in an adequate amount of water to provide complete coverage. See table below for rates of product and application intervals. Apply DACONIL Ultrex Fungicide when conditions favor disease development and repeat applications as long as these conditions persist. Under severe disease conditions, use the curative rates and spray on a 7 day schedule. 

Tank Mixtures:
DACONIL Ultrex Fungicide can be tank-mixed with ONLY ONE of the following partners: Banner MAXX Fungicide or Primo MAXX Turf Growth Regulator. Read all the labels and follow the precautionary statement, directions for use (rates, diseases controlled and application intervals) and other restrictions.
1. Always check the compatibility of Banner MAXX Fungicide, Primo MAXX Turf Growth Regulator tank mix using a jar test with proportionate amounts of DACONIL Ultrex Fungicide, and water, before mixing in the spray tank.
2. Provide sufficient jet or mechanical agitation during filling and application to keep the tank mix uniformly suspended.
3. Fill tank at least 1/2 full of clean water.
4. Add DACONIL Ultrex Fungicide first, then Banner MAXX Fungicide or Primo MAXX or as a tank mix partner. Do not leave tank mix combinations in the spray tank for prolonged periods without agitation. Mix and apply them at the same day.
Dollar Spot Control: Apply DACONIL Ultrex Fungicide at a rate of 115 g/100 m2 as a tank mix with Banner MAXX Fungicide at rate of 30 ml/100 m2.

ORNAMENTALS AND CONIFERS:
Apply DACONIL Ultrex Fungicide at rate of 1.5kg per 1000 liters of water unless other directions are given in the tables below. For ornamentals, apply sufficient spray to obtain adequate coverage, but do not exceed 2000 liters of water per hectare. Begin applications as directed for each species and disease condition cited and repeat on a 7 to 14 day schedule until conditions are no longer favorable for disease development. During periods when conditions favor severe disease incidence, generally cloudy or wet weather, use the higher rate specified and the shortest indicated interval between applications.
DACONIL Ultrex Fungicide may be used in greenhouse. DO NOT use mistblowers or high pressure spray equipment when making applications of DACONIL Ultrex Fungicide in greenhouses. Use of DACONIL Ultrex Fungicide is recommended for disease control on the ornamentals and conifers listed in the tables below. Use of DACONIL Ultrex Fungicide is not recommended for species that are not listed.