Emtrol Ten Tobacco Sucker Control

Manufacturer
Others
Registered until
2023-12-31
Registration number
11581
Active materials
Links

DIRECTIONS FOR USE
Field sprayer application:
DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) coarse classification. Boom height must be 60 cm or less above the crop or ground.
DO NOT apply by air.
Buffer zones:
Use of the following spray methods or equipment DO NOT require a buffer zone: hand-held sprayer and spot treatment.
The buffer zones specified in the table below are required between the point of direct application and the closest downwind edge of sensitive terrestrial habitats (such as grasslands, forested areas, shelter belts, woodlots, hedgerows, riparian areas and shrublands), sensitive freshwater habitats (such as lakes, rivers, sloughs, ponds, prairie potholes, creeks, marshes, streams, reservoirs and wetlands) and estuarine/marine habitats.

HOW TO APPLY: Before entering the rows to start spraying, run all the nozzles for about 10 seconds to flush out the lines and to be sure that the proper concentration of spray mixture will be applied.
Apply the well agitated EMTROL TEN® water mixture as a coarse spray. Direct the coarse spray pattern from each 3 nozzle row assembly to the top centre of the plant to ensure maximum wetting of the top suckers and flow down the stalk to the base of the plant.
Always mix the contents of the spray tank for a few minutes and flush the lines for a few seconds if the machine was left idle.

Registered for cultures
Tobacco