FlagshipPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

For control of insect pests on outdoor ornamentals, greenhouse peppers and Viburnum in outdoor nurseries and landscapes.

STORAGE
Store in a cool, dry place.

DECONTAMINATION AND DISPOSAL
For information on d isposal of unused, unwanted product, contact the manufacturer or the provincial regulatory agency. Contact the manufacturer and the provincial regulatory agency in case of a spill, and for cleanup of spills.

CONTAINER DISPOSAL:
For recyclable containers:
Do not reuse this container for any purpose. This is a recyclable container, and is to be disposed of at a container collection site. Contact your local distributor/dealer or municipality for the location of the nearest collection site. Before taking the container to the collection site:
1. Triple- or pressure-rinse the em pty container. Add the rinsings to t he spray mixture in the tank.
2. Make the empty, rinsed container unsuitable for further use.
If there is no container collection site in your area, dispose of the container in accordance with provincial requirements.
For returnable containers:
DO NOT re use this container for any purpose. For disposal, this empty container may be returned to the point of purchase (distributor/dealer).
For refillable containers:
For disposal, this container may be returned to the point of purchase (distributor/dealer). It must be refilled by the distributor/dealer with the same product. Do not reuse this container for any other purpose.

GENERAL INFORMATION
FLAGSHIP Insecticide controls chewing insects through contact and ingestion.
FLAGSHIP Insecticide should be applied to plant foliage when insect pest populations begin to build, but before pest populations reach economically damaging levels. Economic thresholds for pests controlled by FLAGSHIP Insecticide may be available from your local agricultural authorities.
FLAGSHIP Insecticide is taken up into foliage after application. However, thorough spray coverage is essential for best performance. Apply FLAGSHIP Insecticide in sufficient water to ensure good coverage. See specific application information in the Directions for Use section of this label. The use of higher water volumes will generally result in better coverage, especially under adverse conditions (e.g. hot, dry weather) or where a dense plant canopy exists.
FLAGSHIP Insecticide is rainfast once the spray solution has dried on treated plants.

DIRECTIONS FOR USE
As this product is not registered for the control of pests in aquatic systems, DO NOT use to control aquatic pests.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
DO NOT allow effluent or runoff from greenhouses containing this product to enter lakes, streams, ponds or other waters.
Apply FLAGSHIP Insecticide using sufficient water volume to provide thorough and uniform coverage. Use a minimum of 100 L/ha unless otherwise indicated on this label. In situations where a dense canopy exists and/or pest pressure is high, use greater water volumes. Avoid making applications under conditions where uniform coverage cannot be obtained or where excessive spray drift may occur. Avoid spray overlap.
Precautions:
1) When using water volumes of 100 L/ha, fine-sized droplets may be used to improve spray coverage.
2) Select nozzles that can produce the desired droplet sizes at the normal rated pressure range.
3) When spraying fine-sized droplets, carefully check all nozzles for flow and calibrate the sprayer.
4) The sprayer should travel at a uniform speed.
5) Monitor environmental conditions and follow Recommendations to Avoid Spray Drift carefully.
Field sprayer application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) fine classification. Boom height must be 60 cm or less above the crop or ground.

MIXING PROCEDURES
Prepare no more spray mixture than is needed for the immediate operation. Thoroughly clean spray equipment before using this product. Vigorous agitation is necessary for proper dispersal of the product. Maintain maximum agitation throughout the spraying operation. Do not let the spray mixture stand overnight in the spray tank. Flush the spray equipment thoroughly following each use and apply the rinsate to a previously treated area. Keep product container tightly closed when not in use.
1. Add 1/2 of the required amount of water to the mix tank.
2. With the agitator running, add the desired amount of FLAGSHIP Insecticide to the tank.
3. Continue agitation while adding the remainder of the water.
4. Begin application of the solution after FLAGSHIP Insecticide has completely dispersed into the mix water.
5. Maintain agitation until all of the mixture has been applied.

ROTATIONAL RESTRICTIONS
Treated areas may be replanted immediately following harvest or as soon as practical following the last application with any crop listed on this label or to sorghum, wheat, barley, and canola. Any cover crop planted for erosion control or soil improvement may be planted as soon as practical following the last application. However, the cover crop may not be grazed or harvested for food or feed. For all other crops, a 120 day plant-back interval must be observed.