Fluoxastrobin STPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INFORMATION
Section 1: The Product
FLUOXASTROBIN ST Seed Treatment Fungicide is a broad spectrum seed treatment labeled for the control or suppression of certain plant pathogenic fungi. FLUOXASTROBIN ST Seed Treatment Fungicide provides control of seed rot and pre-emergence damping off caused by seedborne Aspergillus spp. and Penicillium spp., and aids in the suppression of late-season stalk rot caused by Colletotrichum graminicola.
FLUOXASTROBIN ST Seed Treatment Fungicide may be applied in commercial treating equipment which can accurately control application rates and provide good distribution of the chemical onto the seed in the mixing chamber.

DIRECTIONS FOR USE
FLUOXASTROBIN ST Seed Treatment Fungicide is a seed treatment formulation for use in commercial seed treatment operations with conventional seed treating equipment which can accurately meter, mix and apply flowable seed treatment formulations. Allow seeds to dry before bagging, storing or seeding.
This product is recommended to be diluted with water or another suitable liquid just prior to application to ensure uniform coverage to the seed during the application process. Uniform application to seed is necessary to ensure best disease protection and seed safety.
When applied with seed treatment application equipment designed to treat seed utilizing a treatment slurry mixture, add approximately 1/2 to 2/3 of the required water to the treatment slurry tank followed by the accompanying seed treatment products and FLUOXASTROBIN ST. The order of product addition is dependent on the accompanying seed treatment products and application equipment used. Allow each slurry component to disperse completely prior to the next addition until a uniform suspension is obtained. After all slurry components have been added and dispersed completely add the remaining 1/2 to 1/3 of required water for proper slurry volume and mix until uniform. Do not store mixed slurries for greater than 72 hours. Maintain adequate agitation until treatment slurry is applied. For additional instructions for use, slurry component mixing order, and other application suggestions contact your Bayer CropScience representative.
FLUOXASTROBIN ST Seed Treatment Fungicide-treated seed may reduce seed flow in the seed drill. Recalibration of the seed drill may be required to obtain correct seeding rate before planting.
As this product is not registered for the control of pests in aquatic systems, DO NOT use to control aquatic pests.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.

Section 8: Pests Controlled
FLUOXASTROBIN ST is a broad spectrum seed treatment labeled for the control of seed rot and preemergence damping off caused by seed-borne Aspergillus spp. and Penicillium spp., and the suppression of seed-borne Colletotrichum graminicola which may lead to the suppression of anthracnose stalk rot caused by seed-borne C. graminicola later in the growing season.