NexicorPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INFORMATION

This package contains Nexicor, a 355 g/L emuslifiable concentrate. The active ingredients in Nexicor belongs to the carboxamides (SDHI), strobilurins (QoI), and triazoles (DMI) groups of fungicides.
Nexicor has a protective effect because it inhibits spores germination and a curative-eradicative effect because it inhibits mycelial growth and sporulation of susceptible fungi on the leaf surface.
Nexicor should be applied prior to disease development or at the onset of disease symptoms.
Under high disease pressure, optimum disease control is achieved when an application of Nexicoris followed by an application with another fungicide. A fungicide from a different mode of action group other than group 3, 7 or 11 should be used if possible.
DIRECTIONS FOR USE (See specific sections for each crop group)
Nexicor contains three active ingredients. The rate of the group 3 active (propiconazole) has been, in some cases, reduced from the registered solo rates. The rate of the group 7 active (fluxapyroxad) has been significantly reduced compared to the registered solo rates. To maintain efficacy, do not apply Nexicor below the labeled rate.
Apply recommended rates of Nexicor as instructed in the following series of crop application rate tables. Apply Nexicor with ground or aerial spray equipment as specified. Equipment should be checked frequently for proper calibration.
As this product is not registered for the control of pests in aquatic systems, DO NOT use to control aquatic pests.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.

Ground application
Apply Nexicor at rates listed in the Application Rate and Timing Tables (crop specific) when conditions are favourable for the development of disease. Use a minimum water volume of 100 L/ha and ensure thorough coverage of foliage. Consult nozzle manufacturers recommendation for spray pressures for specific nozzles.

Aerial application
Apply Nexicor at rates listed in application rate and timing tables (crop specific) when conditions are favourable for the development of disease. Use a minimum water volume of 50 L/ha. Ensure thorough coverage of foliage. Consult nozzle manufacturers recommendation for spray pressures for specific nozzles.

Instructions for Aerial Applications
Apply only by fixed-wing or rotary aircraft equipment which has been functionally and operationally calibrated for the atmospheric conditions of the area and the application rates and conditions of this label. Label rates, conditions and precautions are product specific. Read and understand the entire label before opening this product. Apply only at the rate recommended for aerial application on this label. Where no rate for aerial application appears for the specific use, this product cannot be applied by any type of aerial equipment. Ensure uniform application. To avoid streaked, uneven or overlapped application, use appropriate marking devices.

Use Precautions
Apply only when meteorological conditions at the treatment site allow for complete and even crop coverage. Apply only under conditions of good practice specific to aerial application as outlined in the National Aerial Pesticide Application Manual, developed by the
Federal/Provincial/Territorial Committee on Pest Management and Pesticides.
Do not apply to any body of water. Avoid drifting of spray onto any body of water or other nontarget areas. Specified buffer zones should be observed.
Coarse sprays are less likely to drift, therefore, avoid combinations of pressure and nozzle type that will result in fine particles (mist). Do not apply during periods of dead calm or when wind velocity and direction pose a risk of spray drift. Do not spray when the wind is blowing towards a nearby sensitive crop, garden, terrestrial habitat (such as shelter-belt) or aquatic habitat.