Pinnacle Toss-N-GoPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

PRODUCT DESCRIPTION:

PINNACLE Toss-N-Go Herbicide is recommended for selective postemergence control of broadleaf weeds in soybeans and field tomatoes. PINNACLE Toss-N-Go Herbicide is in the form of a dry flowable granule to be mixed in water and applied as a uniform broadcast spray. It is noncorrosive, nonflammable, nonvolatile, and does not freeze.
PINNACLE Toss-N-Go Herbicide must be applied with a recommended surfactant early postemergence to the main flush of actively growing weeds. Warm, moist growing conditions promote active weed growth and enhance the activity of PINNACLE Toss-N-Go Herbicide by allowing maximum foliar uptake and contact activity. Weeds hardened off by environmental stress may not be adequately controlled or suppressed and regrowth may occur. PINNACLE Toss-N-Go Herbicide may only be applied using ground equipment. For best results ensure thorough spray coverage of target weeds. Refer to "RATES AND TIMING" section of the label for complete use details.
PINNACLE Toss-N-Go Herbicide rapidly stops growth of susceptible weeds. However, typical symptoms (discolouration) of dying weeds may not be noticeable for 1 to 3 weeks after application, depending on growing conditions and weed susceptibility. Favourable growing conditions following treatment promote the activity of PINNACLE Toss-N-Go Herbicide while cold, dry conditions delay the activity.
Degree of control and duration of effect depend on weed sensitivity, weed size, crop competition, growing conditions and spray coverage.
PINNACLE Toss-N-Go Herbicide may be applied on all soil types.

DIRECTIONS FOR USE

Thifensulfuron-methyl is formulated as a wettable granule or a soluble granule sealed within a water-soluble package (WSP). Drop intact WSP directly into spray tank. The WSP and pesticide will dissolve readily in water.
Do not allow the WSP to become wet prior to use. Do not handle individual WSP with wet hands or wet gloves as this may cause breakage. Do not remove WSP from overwrap container except for immediate use.
DO NOT open WSP or attempt to remove the contents from them. The contents are not designed to be re-measured or subdivided
Do not use opened or punctured WSP.
If broken WSP is found when the over-wrap bag is opened, avoid contact with, and inhalation of the product. Handle with chemical-resistant gloves and dispose of broken WSP according to the DISPOSAL section.

Field sprayer application:
DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty.
DO NOT apply with spray droplets smaller than the ASAE medium classification.