USF 2010Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

For control of foliar diseases in wheat (winter, spring, hard red, durum, Canada prairie, soft white), spring barley, oats and soybean.

GENERAL INFORMATION:
Introduction
USF 2010 FUNGICIDE is a broad-spectrum systemic fungicide for control of a wide range of diseases on certain crops. USF 2010 FUNGICIDE will protect the crop from yield and quality losses due to disease.

Crop Information:
USF 2010 FUNGICIDE may be applied to:
Winter Wheat
Spring Wheat (including Hard Red, Durum, Canada Prairie, Soft White)
Spring Barley
Oats
Soybean

Factors Affecting USF 2010 FUNGICIDE Performance:
USF 2010 FUNGICIDE should be applied as a preventative disease control measure or at the very early stages of disease development. Established diseases are more difficult to control and may have already reduced crop vigour.
If rainfall occurs within one hour of application, reapplication may be necessary.

DIRECTIONS FOR USE:
Application instructions:
As this product is not registered for the control of pests in aquatic systems, DO NOT use to control aquatic pests. DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
Field sprayer application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE S572.1) medium classification. Boom height must be 60 cm or less above the crop or ground.
Aerial application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply when wind speed is greater than 16 km/h at flying height at the site of application. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE S572.1) medium classification. To reduce drift caused by turbulent wingtip vortices, the nozzle distribution along the spray boom length MUST NOT exceed 65% of the wing- or rotorspan.
The spray drift buffer zones required for the protection of terrestrial habitats for this product can be modified based on weather conditions and spray equipment configuration by accessing the Buffer Zone Calculator on the Pest Management Regulatory Agency web site.

APPLICATION IN FIELDS ADJACENT TO AQUATIC AREAS: Observe the following precautions when spraying in the vicinity of aquatic areas such as lakes, rivers, slough, ponds, prairie potholes, creeks, marshes, streams, reservoirs and wetlands and estuaries:
- DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes. To reduce runoff from treated areas into aquatic habitats avoid application to areas with a moderate to steep slope, compacted soil, or clay. Avoid application when heavy rain is forecast. Contamination of aquatic areas as a result of runoff may be reduced by including a vegetative strip between the treated area and the edge of the water body.
- DO NOT apply by ground or air within 30 metres of aquatic areas listed above.
- DO NOT cultivate within 3 metres of an aquatic area to allow growth of vegetative filter strip.
- The aquatic buffer zone of 30 meters may not be modified by the Buffer Zone Calculator on the Pest Management Regulatory Agency web site.