Warhawk 480 ECPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INFORMATION

WARHAWK 480 EC INSECTICIDE is active against various insect pests bycontact and ingestion. It is not systemic in the plant. Treatment of plants that are under extreme drought stress may result in some crop damage. The active ingredient in this product is decomposed by sunlight.

PRECAUTIONS FOR USE

Do not spray under windy conditions or from spraying equipment which could be expected to cause spray drift onto nearby crops or pastures. Do not mix with other pesticides when used on vegetables. Compatible with most commonly used pesticides except those that are alkaline. Do not add any additional adjuvants, surfactants, or spreader-stickers.

PRECAUTIONS FOR MIXERS/LOADERS
For liquid formulations packaged in containers more than 10 L
Mixers/loaders must use a closed mechanical transfer loading system.
Mixers/loaders must wear:
• coveralls over a long-sleeved shirt and long pants;
• chemical-resistant gloves;
• an air purifying respirator with an -R or -P series filter; and
• socks and shoes.
For liquid formulations packaged in containers holding 10 L or less
Mixers/loaders must wear:
• coveralls over a long-sleeved shirt and long pants;
• chemical-resistant gloves;
• a chemical-resistant apron;
• chemical-resistant footwear plus socks; and
• an air purifying respirator equipped with an -R or -P seriesfilter.

DIRECTIONS FOR USE

MIXING: To prepare the spray, add approximately 1/4 of the required amount of water to the clean spray tank, add required quantity of product and mix well. Complete filling the tank with the balance of the water needed.
Do not allow the pesticide to come into contact with the water intake pipe. Maintain sufficient agitation during both mixing and application to ensure uniformity of the spray mixture.
To avoid injury to the crop, mix only with pesticides listed on this label.
For all applications: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty.
For aerial applications: DO NOT apply when wind speed is greater than 16 km/h at flying height at the site of application. The nozzle type is restricted to CP®, with the following set-up restriction:

Nozzle Type Restriction
CP DO NOT use greater than 30° deflection
For airblast applications: Airblast applications are only permitted on peaches and nectarines. DO NOT direct spray above plants to be treated. Turn off outward pointing nozzles at row ends and outer rows. DO NOT apply when wind speed is greater than 16 km/h at the application site as measured outside of the treatment area on the upwind side.

Buffer Zones
The buffer zones specified in the following tables are required between the point of direct application and the closest downwind edge of sensitive freshwater habitats (such as lakes, rivers, sloughs, ponds, prairie potholes, creeks, marshes, streams, reservoirs and wetlands), estuarine habitats and marine habitats.

Aerial Applications
For all aerial applications, a buffer zone of 100 metres is required for the protection of aquatic habitats.