Ally Ultra

Manufacturer
DU PONT
Category
Herbicides
Registered until
Registration expired
Registration number
05075
Active materials
Links

A water soluble granule formulation containing 105 g/kg florasulam, 83 g/kg metsulfuron-methyl and 83 g/kg tribenuron-methyl and for weed control in wheat, barley, oats, rye and triticale

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.

Restrictions
ALLY ULTRA should not be applied to any crop suffering from stress as a result of drought, waterlogging, low temperatures, pest or disease attack, nutrient or lime deficiency or other factors reducing crop growth.
Do not use ALLY ULTRA on cereal crops undersown with grasses, clover or other legumes or any other broad-leaved crop.
Due to the high level of activity of the herbicide, special care must be taken to avoid damage by drift onto broad-leaved plants outside the target area, or onto ponds, waterways or ditches. Thorough cleansing of equipment is also very important - see below.
Contract agents should be consulted before using on crops grown for seed.
ALLY ULTRA should not be applied within 7 days of rolling the crop.
Do not apply ALLY ULTRA more than once to any cereal crop.
All requirements or restrictions on other product labels must be adhered to when applied to the same crop as ALLY ULTRA. Contact your DuPont distributor for further information.

Weed control
ALLY ULTRA contains florasulam, metsulfuron methyl and tribenuron methyl, sulfonylurea (ALS inhibitor) herbicides which work mainly by contact action and is most effective if applied when the weeds are small and actively growing. Good spray cover of the weeds must be obtained for best results. Susceptible plants cease growth almost immediately after application and symptoms can be seen about two weeks after application. Weed control may be reduced when soil conditions are very dry. The susceptibility rating of the following weeds refer to good spray cover and good growing conditions and up to 6 true leaves in size.

Resistance
When herbicides with the same mode of action are used repeatedly over several years in the same field, selection of resistant biotypes can take place. These can propagate and may become dominating. A weed species is considered resistant to a herbicide if it survives a correctly applied treatment at the recommended dose. Development of resistance with a weed species can be avoided or delayed by alternating (or tank mixing) with suitable products having a different mode of action. For control of Chickweed this product must always be applied with an alternative mode of action product at recommended rates. 

Crops
ALLY ULTRA can be used on all winter and spring varieties of wheat, barley, oats, rye and triticale between the growth stages given below.

Dose
Apply ALLY ULTRA at 50 g/ha.

Timing
ALLY ULTRA should be applied in the spring after 1st February from the two-leaf stage (GS 12) up to and including the flag leaf ligule/collar just visible (GS 39).

Following crops
Only cereals, oilseed rape, field beans or grass may be sown in the same calendar year as harvest of a cereal crop treated with ALLY ULTRA. In case of crop failure for any reason, sow only cereals within three months of application of ALLY ULTRA. Before sowing, soil should be ploughed and cultivated to a depth of at least 15-cm.

Volume and application
BEFORE USING ALLY ULTRA, SPRAYING EQUIPMENT MUST BE CLEAN AND FREE FROM CONTAMINATION WITH OTHER PESTICIDES. Application should be made in 100-200 litres of water per hectare, using suitable ground equipment to give good spray cover of the weeds. When crops are thick or weed growth is dense, use 400 litres of water per hectare. Care should be taken not to overlap spray swaths

Mixing
Quarter fill the spray tank with clean water, start the agitation and add the required quantity of ALLY ULTRA directly to the tank without prior creaming. Continue agitation while topping up the tank and while spraying.

Compatibility
In any tank-mix add ALLY ULTRA to the tank first and ensure it is fully dispersed before adding the partner product. Do not allow ALLY ULTRA to come into contact with undiluted pesticide concentrate. Products should only be tankmixed if each product can be applied within the label recommendations for its use. For further information contact your DuPont distributor.

Registered for culturesRateBBCH
Winter wheat50 g12 - 39
Spring wheat50 g12 - 39
Spring barley50 g12 - 39
Winter barley50 g12 - 39
Spring oats50 g12 - 39
Winter oats50 g12 - 39
Winter rye50 g12 - 39
Spring rye50 g12 - 39
Winter triticale50 g12 - 39
Spring triticale50 g12 - 39