Beret MultiPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

FORMULATION & ACTIVE INGREDIENT: BERET MULTI is a flowable concentrate for seed treatment containing 25 g/l (2.34% w/w) fludioxonil and 25 g/l (2.34% w/w) flutriafol.

GENERAL INFORMATION
Results from trials have shown BERET MULTI to be well tolerated over a wide range of sowing dates and conditions. However under adverse environmental or soil conditions, the germination capacity of seed may be reduced and therefore seed rates should be increased in accordance with good agricultural practice.
BERET MULTI is effective against benzimidazole resistant and sensitive forms of Microdochium nivale.

DISEASES CONTROLLED
Winter and spring wheat
BERET MULTI controls Microdochium nivale resulting in reductions in Seedling Blight, Stem-Base Browning, Snow Mould and Septoria Seedling blight, and controls seed-borne and soil-borne Common Bunt (Tilletia caries), and loose smut (Ustilago tritici).
Winter and spring barley
BERET MULTI controls loose smut (Ustilago nuda) and barley leaf stripe (Pyrenophora graminea).
Winter and spring oats
BERET MULTI controls Microdochium nivale resulting in reductions in Seedling Blight and Stem-Base Browning. Pyrenophora Leaf Spot (Pyrenophora avenae).

CROP SPECIFIC INFORMATION
Crops
BERET MULTI is recommended as a seed treatment for use on winter and spring crops of wheat, barley and oats.
Timing
Before drilling.
Rates of use
2.0 litres BERET MULTI per tonne of seed.

DIRECTIONS FOR USE
This container should be handled only by mechanical means (200 litre contrainer only).
Read the full directions on the pack label before use.

Application
BERET MULTI should be applied directly to the seed using conventional seed treatment equipment.
Continuous flow treaters should be calibrated using BERET MULTI before use.
Do not apply BERET MULTI to cracked, split or sprouted seed.
Dose
2.0 litres BERET MULTI per tonne of seed.

MIXING AND SPRAYING
For 200 litre containers. Prior to use, the drum should be agitated by rolling the drum on its base to ensure uniform distribution of the product in the tank prior to application. This should be done using suitable mechanical means.
BERET MULTI should be applied directly to the seed using conventional seed treatment equipment. The container should be connected to the seed treater suction hose using the dry break coupling provided.

The empty container should not be rinsed out but should be stored in a purpose built chemical store and subsequently returned to the supplier for refilling.

Storage after treatment
Ensure seed is of a satisfactory moisture content before storage. Keep in a dry place correctly labelled.

Seed bag labels are available from Syngenta Ireland Ltd.

Drilling
Seed treated with BERET MULTI may affect the flow rate of seed through drills. It is therefore
important to check the calibration of the drill with BERET MULTI treated seed before drilling commences.