Clayton Flurry
- Manufacturer
- Clayton Plant Protection
- Category
- Herbicides
- Registered until
- N/A
- Registration number
- 06638
- Active materials
- fluroxypyr200 g/l
DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.
CLAYTON FLURRY contains fluroxypyr, a translocated herbicide taken up by the leaves. Weeds emerging after application will not be controlled. Best weed control is achieved when applied when weeds are actively growing.
RESTRICTIONS
Do not apply when during periods of cold weather of if frost is forecast.
Do not roll or harrow crops within 7 days of treatment.
Do not apply on crops undersown with clovers or other legumes
Do not use on crops grown for seed production
Do not sow legumes e.g. peas, beans, clovers for 12 months on land treated with 2 L/ha. All manure or crop residues derived from crops treated with 2 L/ha must be returned to grassland or land to be cropped with cereals.
APPLICATION METHOD
Spray equipment should be thoroughly cleaned before use. Apply with tractor mounted/trailed sprayer in 150-400 litres of water per hectare. The higher volume is recommended on dense crops to ensure good coverage and penetration. Apply as a MEDIUM quality spray. A spray pressure of 2-2.5
Bar is recommended.
Where overall spraying is not justified, CLAYTON FLURRY may be applied by knapsack sprayer or hand-lance. Spray to just wet the foliage evenly but before run-off occurs.
MIXING
Shake the can before use. Add the required quantity to the half-filled tank and then complete filling.
Continue agitation until the tank is empty. Spray equipment should be cleaned immediately after use.
Registered for cultures | Rate | BBCH |
---|---|---|
Winter wheat | 0.5 l | 0 - 31 |
Spring wheat | 0.5 l | 0 - 31 |
Winter barley | 0.5 l | 0 - 31 |