Delaro FortePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

A fungicide for the control of foliar diseases in wheat, barley, rye and triticale.

DIRECTIONS FOR USE

IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.
Delaro Forte is a mixture of a carboxamide, spiroketoalamine and a strobilurin fungicides recommended for control of a wide range of diseases on wheat, barley, rye and triticale.

Other specific restrictions

Do not apply product prior to the beginning of stem elongation (BBCH30)
Method of application: Tractor mounted/trailed horizontal sprayer
A spray pressure of 2-3 bar is recommended. Apply Delaro Forte in 100-400 litres per hectare water.
Apply as a medium spray quality.

CROPS
Delaro Forte may be used on all commercial varieties wheat, barley, rye and triticale.

RATE OF USE
Apply Delaro Forte at 1.5 litre per hectare.

APPLICATION
Water volume
Apply Delaro Forte in 100-400 litres water per hectare. The higher spray volumes are recommended where the crop is dense or disease pressure / risk is high to ensure good penetration to the lower leaves and stem bases. Disease control may be compromised by reducing water volumes, where good spray coverage is difficult to achieve.
A spray pressure of 2-3 bar is recommended.

Spray quality
Apply as a MEDIUM spray quality (as defined by BCPC).
Latest Permitted Timing
In barley Delaro Forte may be applied at any stage up to beginning of flowering, In wheat, rye and triticalebefore grain milky ripe stage.

Mixing
Thoroughly shake the pack before use.
Add the required quantity of Delaro Forte to the half-filled spray tank with the agitation system in operation and then fill to the required level. Continue agitation at all times during spraying and stoppages until the tank is completely empty. Spray immediately after mixing.

General
Sprayers should be thoroughly cleaned with water and detergent after use, and filters and jets checked for damage and blockages.
Boom height should be adjusted to ensure even coverage of the crop, particularly at later growth stages. The correct height is one at which the spray from alternate nozzles meets just above the crop, In dense crops, at later growth stages, higher water volumes should be used.