Farmco Lenzo FloPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

A suspension concentrate containing 440 g/l lenacil.
For the control of weeds in beet.

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.

GENERAL INFORMATION
FARMCO LENZO FLO is a residual herbicide with some contact activity for post-emergence use on sugar beet and fodder beet. Best control is achieved when used in a low volume overall spray programme with other approved herbicides. Weed control may be reduced when soil conditions are very dry.

WEEDS CONTROLLED
The susceptibility ratings of weeds in the following table refer to good spray cover and good growing conditions, with weed size of up to 2 true leaves.

Weed Resistance
When herbicides with the same mode of action are used repeatedly over several years in the same field, selection of resistant biotypes can take place. These can propagate and may become dominating. A weed species is considered resistant to a herbicide if it survives a correctly applied treatment at the recommended dose. Development of resistance with a weed species can be avoided or delayed by alternating (or tank-mixing) with suitable products having a different mode of action.

Crops
FARMCO LENZO FLO can be used on all varieties of sugar beet and fodder beet at the growth stage given below.

Timing
Application should be made when the crop has reached the cotyledon stage. Subsequent applications should be applied as new flushes of weeds-emerge.
Avoid high light intensity (full sunlight) and high temperatures (above 21°C) on the day of spraying. Avoid periods of substantial day to night temperature changes or when frost is expected.

Volume & Application
Before using FARMCO LENZO FLO, spraying equipment must be clean and free from contamination with other pesticides.
FARMCO LENZO FLO should be applied overall in 80-150 l/ha of water, using suitable equipment to give a FINE quality spray. Good, even coverage of the weeds is essential for best results. Care should be taken not to overlap spray swaths.

Dose
FARMCO LENZO FLO should be applied at 0.4l/ha in tank mix with a suitable herbicide partner (see Weed Susceptibility Table). A maximum total dose of 1 l/ha may be applied to acrop.

SOIL Type
FARMCO LENZO FLO can be used on all soil types except sands, stony or gravelly soils and on soils with more than 10% organic matter. Weed control may be reduced when soil conditions are very dry.

Mixing
FARMCO LENZO FLO mixes easily with water, but the following mixing procedure should be followed: Quarter fill the spray tank with water, start the agitation and add the required quantity of FARMCO LENZO FLO. Continue agitation while topping up the tank and while spraying. Do not leave the sprayer standing without agitation with chemical in it. Follow the manufacturer’s recommendations for mixing with phenmedipham based products.

Compatibility
Products should only be tank-mixed if each product can be applied within the manufacturers label recommendations for its use.