IncaPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

A suspension concentrate formulation containing 125 g/l (12.1 % w/w) epoxiconazole. Also contains solvent naptha and alkoxylated fatty alcohol.
A broad-spectrum systemic fungicide for control of Septoria, yellow and brown rust, eyespot, net blotch, Rhynchosporium, powdery mildew, Fusarium and sooty moulds in barley, wheat, triticale, rye and oats.

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product. Do not contaminate water with the product or its container. Do not clean application equipment near surface water. Avoid contamination via drains from farmyards and roads.

RESTRICTIONS
Avoid drift onto neighbouring crops, as damage may occur, particularly to broad-leaved plants.
Malting barley
INCA™ is accepted by the Brewers and Licensed Retailers Association to be used on malting barley. Application should be before the start of ear emergence.
Avoid overlapping spray swaths.

RESISTANCE
INCA contains a DMI fungicide. Resistance to some DMI fungicides has been identified in Septoria leaf blotch (Mycosphaerella graminicola) which may seriously affect the performance of some products. For further advice on resistance management in DMIs, contact your agronomist or specialist advisor. The efficacy of this product may be affected if strains of disease pathogens resistant or less sensitive occur at any time. As such occurrences cannot be predicted no responsibility can be accepted for the results obtained. Where strains of wheat powdery mildew with decreased sensitivity to triazoles occur or develop, INCA may not give satisfactory control.

CROP SPECIFIC INFORMATION
INCA can be safely used on all varieties of wheat, barley, oats, rye and triticale. For best disease control, apply as soon as disease is seen. Some specific recommendations can be seen below.

Disease Specific/ recommendations
Fusarium ear blight and sooty moulds
Apply during ear emergence.
Mildew
For better mildew control when disease is established, apply with a specific mildew fungicide.
Septoria tritici and nodorum
Apply when disease is present, or conditions favour disease appearing. This is generally after the 3rd node detectable stage. A follow up treatment may be required.
Eyespot
For optimum control apply between leaf sheath erect stage and 2nd node detectable.

RATE OF USE
Apply 1.0 L/ha in 150-300 L water/ha. Use the higher volume of water for dense crops, or for the second application.
Apply as a medium spray as defined by BCPC

MIXING AND APPLICATION
For use by tractor mounted/trailed sprayer only. Half fill the spray tank with clean water and begin agitation. Add the required quantity of INCA and add the remainder of the water. Continue agitation until spraying is completed. On emptying the container, RINSE CONTAINER THOROUGHLY by using an integrated pressure rinsing device or manually rinsing three times. Add washings to sprayer at time of filling and dispose of container safely. Wash out sprayer thoroughly after use.

COMPATIBILITY
For information on tank-mixes, consult Adama Agricultural Solutions UK Ltd, your agronomist or your distributor.