MaestroPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

An agricultural fungicide for the control of stem-base, foliar and ear diseases in winter and spring barley and oats.

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product. Maestro is a mixture of a strobilurin and a triazolinthione fungicide recommended for control of a wide range of diseases on winter and spring barley and oats.

APPLICATION TIMING
Stem Base Disease Complex and Take-All Eyespot (Oculimacula spp.). Sharp Eyespot (Rhizoctonia cerealis). Take- All (Gaeumannomyces graminis). Fusarium Foot rot (Fusarium culmorum, Microdochium nivale var nivale and majus)
Spray in the spring at the first sign of disease, from when the leaf sheaths begin to become erect until the 2nd node is detectable (GS 30-32.

Powdery Mildew (Blumeria graminis)
Strains of barley powdery mildew resistant to Qol fungicides are common in Ireland. Where specific control of mildew is required, this should be achieved through a programme of measures, including products with recommendations for control of mildew that contain different active substances used in mixture or sequence.

Brown Rust (Puccinia hordei)
Apply Maestro at the first signs of disease. A second application may be made 2-3 weeks later if re-infection occurs. Applications made to established infections are likely to be less effective.

Crown Rust (Puccinia coronata)
Apply Maestro at the first signs of disease. A second application may be made 2-3 weeks later if re-infection occurs. Applications made to established infections are likely to be less effective.

Leaf Blotch (Rhynchosporium secalis)
Apply Maestro in spring at the first signs of disease. For severe infections a second application may be necessary 2-3 weeks later.

Net Blotch (Pyrenophora teres)
Apply Maestro at the first signs of disease in spring/early summer. For severe infections, a second application 2-3 weeks later will give most effective control when conditions remain favourable for disease development.

CAUTION: The possible development of disease strains resistant to Maestro cannot be excluded or predicted. Where such resistant strains occur, Maestro is unlikely to give satisfactory control.

MANAGEMENT STRATEGY TO MINIMISE THE LIKELIHOOD OF RESISTANCE
Apply fungicides according to manufacturer’s recommendations for the target disease (or complex) at the specific crop growth stage indicated. Effective disease management is a critical parameter in delaying the build-up of resistant pathogen populations. Maestro is a mixture of two fungicides with different modes of action, a strobilurin and a triazolinthione. Maestro contains fluoxastrobin, a member of the Qol cross-resistance group. Maestro should be used preventatively and should not be relied on for its curative potential. Use Maestro as part of an Integrated Crop Management (ICM) strategy incorporating other methods of control, including where appropriate other fungicides with a different mode of action. You must not apply more than two foliar applications of QoI-containing products to any cereal crop. The Fungicide Resistance Action Committee (FRAC) produces recommendations that may be consulted for additional information.

FACTORS AFFECTING CROP SAFETY
Occasionally, after the application of Maestro, some transient leaf chlorosis on barley may occur, but these symptoms have not been shown to adversely affect yield responses accruing from the benefits of disease control.

CROP SPECIFIC INFORMATION
Maestro may be used on all commercial varieties of winter and spring barley and oats.

Mixing
Thoroughly shake the pack before use. Add the required quantity of Maestro to the half-filled spray tank with the agitation system in operation and then fill to the required level. Continue agitation at all times during spraying and stoppages until the tank is completely empty. Spray immediately after mixing. RINSE CONTAINER THOROUGHLY by using an integrated pressure rinsing device or manually rinsing three times. Add washings to sprayer at time of filling and dispose of safely.

General
Sprayers should be thoroughly cleaned before use, and filters and jets checked for damage and blockages. Boom height should be adjusted to ensure even coverage of the crop, particularly at later growth stages. The correct height is one at which the spray from alternate nozzles meets just above the crop, in dense crops, at later growth stages, higher water volumes should be used.