ModdusPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

FORMULATION AND ACTIVE INGREDIENT:
MODDUS is an emulsifiable concentrate containing 250 g/l (25.5% w/w) trinexapac-ethyl.
PCS NUMBER: 03849
PACK SIZE: 1 litre.
TARGETS: MODDUS is a growth regulator for crop height reduction, lodging prevention and yield protection in all varieties of winter and spring wheat, winter and spring barley, winter and spring oats, durum wheat, rye, triticale and grassland (seed crops).
WATER VOLUME AND SPRAY QUALITY: Apply MODDUS in a minimum of 200 l/ha of water. A medium spray quality with spray pressure of 2–3 bar is recommended.
RAINFASTNESS: 2 hours
FOR USE ONLY AS: AN AGRICULTURAL GROWTH REGULATOR.

PROPERTIES OF MODDUS
MODDUS is a growth regulator for crop height reduction, lodging prevention and yield protection in all varieties of winter and spring wheat, winter and spring barley and winter and spring oats, durum wheat, rye, triticale and grassland (seed crops).

MIXING AND SPRAYING
Make sure the sprayer is set to give an even application at the correct volume.
Fill the spray tank with half the required volume of clean water and start agitation. Add the required amount of MODDUS and continue agitation whilst adding the rest of the water.
Agitate the mixture thoroughly before use and continue agitation during spraying. Thoroughly wash all spray and measuring equipment with water and a wetting agent immediately after use.

APPLICATION
Spray volume
Apply MODDUS in a minimum of 200 l/ha of water. Increased penetration will be obtained with an increase in water volume but the necessity for this will be dependent on crop growth stage and habit.

Spray nozzles
A medium spray quality is preferred for application of MODDUS. A spray pressure of 2–3 bar is recommended.

Spraying
Take particular care to avoid overlapping of spray swaths.
Only apply using a ground sprayer.

RECOMMENDATIONS
Winter Barley
Timing and dose
Apply at 0.4 l/ha from the leaf sheath erect stage (GS30) but before the third node detectable stage (GS33).
or
Apply at 0.6 l/ha from the flag leaf just visible stage (GS37) but before the flag leaf extending stage (GS41).

Winter Wheat
Timing and dose
Apply at 0.4 l/ha from the leaf sheath erect stage (GS30) but before the flag leaf fully extending stage (GS41).

Spring Barley
Timing and dose
Apply at 0.5 l/ha from the leaf sheath erect stage (GS30) but before the third node detectable stage (GS33).

Spring Wheat
Timing and dose
Apply at 0.4 l/ha from the leaf sheath erect stage (GS30) but before the third node detectable stage (GS33).

Winter and spring oats
Timing and dose
Apply at 0.4 l/ha from the leaf sheath erect stage (GS30) but before the second node detectable stage (GS32).

Rye,Triticale and Durum Wheat
Timing and dose
Apply at 0.4 l/ha from the leaf sheath erect stage (GS30) but before the third node detectable stage (GS33).

Grassland (seed crops only)
Timing and dose
Apply at 0.8 l/ha from the leaf sheath erect stage (GS30) but before the second node detectable stage (GS32).

CROP FAILURE
In the event of crop failure for any reason, cereals and oilseed rape can be planted in soil treated with MODDUS. Due to reduced activity via the root system and to its rapid degradation in soil, no problems with following crops are foreseen for this product.