Relay PPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Contains 200 g/l (16.5% w/w) mecoprop-p, 200 g/l (16.5% w/w) MCPA and 25 g/l (2.0% w/w) dicamba.

A selective weedkiller for use in grass leys, permanent pastures and amenity turf to control a broad spectrum of annual and perennial weeds.

FOR USE ONLY AS AN AGRICULTURAL / AMENITY HERBICIDE

PERMANENT PASTURE GRASS LEYS
Weeds: Docks, Ragwort, Soft Rush
Rate: 7.0 l/ha
Critical comments: maximum number of treatments 2per year. Latest time of application: 7 days before cutting or grazing.

AMENITY GRASSLAND
Weeds: Docks, Ragwort, Soft Rush
Rate: 5.0 l/ha
Critical comments: maximum number of treatments 2per year.

RATE OF USE IN GRASS LEYS AND PERMANENT PASTURE
Use 5 litres/ha (31 ⁄2 pints/acre) in 200 litres of water/ha (18 gallons/acre). For improved control of Docks, Ragwort and other weeds in grass leys and permanent pastures where the grass has been established for at least 18 months, use 7 litres/ha (5 pints/acre) in at least 200 litres of water /ha (18 gallons/acre). Note: Do not use this higher rate in amenity turf.

TIMING IN GRASS LEYS AND PERMANENT PASTURE
Apply from spring to early October when weeds are growing actively, preferably at the rosette stage. Larger weeds, particularly Docks, Ragwort and Soft Rush may need a further application. In cold weather or in slow growing conditions the inclusion of Headland Intake penetrant will be of benefit.

RATE OF USE IN AMENITY TURF
Use 5 litres/ha (31 ⁄2 pints/acre) in 200 litres of water/ha (18 gallons/acre).

TIMING IN AMENITY TURF
Apply at any time between April and early October when both grass and weeds are growing strongly. Best results will be obtained in fine, warm weather when the soil is moist. If possible, apply a nitrogen fertiliser 7-14 days before treatment. Do not use on new grass for 6 months after establishment.

MIXING AND APPLICATION
Make sure the sprayer has been properly cleaned from any previous use. Half-fill the spray tank with clean water and add the required amount of Headland Relay whilst agitating. Then add the remaining quantity of water and apply without delay. If the machine is stopped for any time, agitate thoroughly before restarting spraying. After use wash out the sprayer thoroughly using a suitable spray tank decontaminant.

COMPATIBILITY
Headland Relay is compatible with many commonly used pesticides and micronutrients. Your Headland distributor will be able to answer any specific questions about compatibility. DO NOT MIX WITH MANGANESE SULPHATE OR FERROUS SULPHATE.