AdexarPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

General Information
ADEXAR is a broad spectrum contact and systemic fungicide with protectant and eradicant activity. ADEXAR is taken up via the stem and foliage and is translocated upwards and outwards to provide some protection of new growth. Thorough coverage of the crop is necessary for best results. ADEXAR has curative activity against early stages of infection but optimum results are obtained from application prior to the onset of infection.

Resistance Management
ADEXAR contains fluxapyroxad, a caroxamide fungicide from the SDHI (Succinate Dehydrogenase inhibitors) mode of action group GROUP 7 FUNGICIDE  , and epoxiconazole, a triazole fungicide in the DMI mode of action group GROUP 3FUNGICIDE . Resistance to this fungicide could develop from excessive use. To minimize this risk use strictly in accordance with label instructions and resistance management strategies that exist for any fungus listed on the label. Frequency of application must be strictly adhered to in accordance with the Directions for Use. ADEXAR should be used in a programme that incorporates fungicides with different modes of action to that of GROUP 7 and GROUP 3 fungicides. Apply no more than two ADEXAR sprays per season. Refer to the NZCPR web site (www.nzpps.org/resistance/index.php) for more detailed information.

Direction for Use
Add the required amount directly into the partly filled spray tank with agitation operating. Complete filling and maintain agitation until spraying is complete. Do NOT leave spray mix standing overnight in the spray tank.

Compatibility:
ADEXAR may be tank mixed with most commonly used fungicides, e.g. Comet®, insecticides, herbicides (e.g fluroxypyr) and growth regulators (e.g. Cycocel® or Terpal®). All tank mixes should be used mmediately after preparation.

Rainfall:
Do NOT apply if rainfall is likely before ADEXAR dries on the crop.

Withholding Periods:
It is an offence for users of this product to cause residues exceeding the relevant MRL in the New Zealand (Maximum Residue Limits of Agricultural Compounds) Food Standards.

Wheat and barley grain: Do NOT harvest within 42 days of application.

Cereal silage/green feed: Allow 28 days between last application and cutting or introduction of stock for grazing.

Handling
This product must be under the personal control of an APPROVED HANDLER when applied in a wide dispersive manner or by a commercial contractor.

Spillage
Prevent further spillage and product from entering waterways. Wear overalls, gloves, footwear and goggles. Sweep up spill and place in a labeled, sealable container for disposal. Wash the spill area with water and detergent, then absorb the washings and place in the same sealable container. Dispose of the waste safely in suitable landfill.

Personal Protection
When mixing and preparing spray, wear cotton overalls buttoned to the neck and wrist, a washable hat, suitable gloves, and goggles or a face shield.

General Safety and Hygiene Measures
Avoid contact with skin, eyes and clothing. Avoid inhalation of dust or spray mist. Do NOT eat, drink or smoke when using this product. Remove protective clothing and wash hands and exposed skin thoroughly with soap and water before meals and after work. Wash protective clothing immediately after use. Store work clothing separately.

First Aid
If medical advice is needed, have product container or label at hand. IF SWALLOWED: Rinse mouth. Do NOT induce vomiting. For advice, contact the National Poisons Centre 0800 POISONS (0800 764 766) or a doctor. IF ON SKIN OR CLOTHING: Remove contaminated clothing and wash skin with plenty of soap and water. Do NOT scrub skin. IF IN EYES: Wash out immediately with water.

Storage
Store in original container, tightly closed, in a locked, dry, cool, well-ventilated place away from food and animal feeds. Keep away from heat and protect from direct sunlight. Stores containing 100 kg or more of this product require emergency response plans and secondary containment systems, and are subject to signage. When stored appropriately this product should show no significant degradation for two years from the date of manufacture. Contact your supplier for further information about the use of any product that is older than this. TRANSPORT: Do NOT carry this product on a passenger service vehicle.